EUROfase 23274 5 Inch Chrome Wall Sconce Wall Light Instruction Manual
- June 12, 2024
- EUROfase
Table of Contents
EUROfase 23274 5 Inch Chrome Wall Sconce Wall Light
Product Information
- Product Model: 23274
- Product Type: Lighting Product
- Power Requirements: 2 X 60W MAX T10, 120V, 60Hz
- Bulbs: Not included
Product Usage Instructions
- Estimated Assembly Time: 20 minutes
- Tools Required For Assembly (not included):
- Flathead screwdriver
- Phillips screwdriver
- Pliers
- Electrical tape
- Wire cutters
- Helpful Tools (not included): Wire strippers, Ladder
- Follow the steps below for assembly:
- Secure the product to the outlet box using the provided screws (A-Outlet Box screw x 2).
- Connect the black wire (L) from the junction box (B) to the black wire (L) from the fixture (E) using a wire connector (H-Wire connector x 1).
- Connect the white wire (N) from the junction box (C) to the white wire (N) from the fixture (F) using a wire connector (H-Wire connector x 2).
- Connect the green wire/bare copper (G) from the junction box (D) to the green wire/bare copper from the fixture (G) using a wire connector (H-Wire connector x 3).
- Make sure all connections are secure and properly insulated with electrical tape.
- If required, use wire strippers to strip the insulation off the wires for better connectivity.
- Once assembly is complete, refer to the user manual for further instructions on operating and maintaining the lighting product.
Note: For any future reference, please save these instructions.
INSTRUCTIONS
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
- Follow the assembly instructions by reading the numerical progression.
- Use a qualified electrician for installation of this lighting fixture.
- Before installing fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box.
- All electrical connections must be in accordance with local and National Electrical Code or Canadian Electrical Code standards.
- Use CSA or UL listed wire connectors suitable for the gauge, type and number of conductors.
- Attach junction box grounding wire (green or bare copper) and the bare copper wire from the fixture together. If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
Estimated Assembly Time: 20 minutes
Tools Required For Assembly (not included):
- Flathead screwdriver
- Phillips screwdriver
- Pliers
- Electrical tape
- Wire cutters.
Helpful Tools (not included):
- Wire strippers
- Ladder
DESCRIPTION
2 X 60W MAX T10,120V,60Hz (Bulbs not included)
- A- Outlet Box screw x 2
- B- Black wire(L) from junction box
- C- White wire(N) from junction box
- D- Green wire/Bare copper (G) from junction box
- E- Black wire (L) from fixture
- F- White wire (N) from fixture
- G- Green wire/Bare copper from fixture
- H- Wire connector x 3
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>