EUROfase 39466 Barletta 12 Light LED Chandelier Instruction Manual
- June 12, 2024
- EUROfase
Table of Contents
EUROfase 39466 Barletta 12 Light LED Chandelier
Product Information
The product consists of the following components:
- A-Outlet Box screw x 2
- B-Black wire(L) from junction box
- C-White wire(N) from junction box
- D-Green wire/Bare copper (G) from junction box
- E-Black wire (L) from fixture
- F-White wire (N) from fixture
- G-Green wire/Bare copper from fixture
- H-Wire connector x 3
Product Usage Instructions
Follow the steps below to correctly use the product:
- Start by attaching the A-Outlet Box screws to the appropriate outlet box.
- Connect the B-Black wire (L) from the junction box to the corresponding black wire (L) from the fixture. Use one of the H-Wire connectors to secure the connection.
- Connect the C-White wire (N) from the junction box to the corresponding white wire (N) from the fixture. Use another H-Wire connector for this connection.
- Connect the D-Green wire/Bare copper (G) from the junction box to the G-Green wire/Bare copper from the fixture. Secure the connection with a H-Wire connector.
- Make sure all connections are tight and secure.
Thank You You’ve just purchased a lighting product designed and built to provide you with years of enjoyment.
INSTRUCTIONS
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
- Follow the assembly instructions by reading the numerical order.
- Use a qualified electrician for installation of this lighting fixture.
- Before installing fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box.
- Use CSA or UL certified wire connectors suitable for the gauge, type and number of conductors.
- All electrical connections must be in accordance with local and National Electrical Code or Canadian Electrical Code standards.
- Attach junction box grounding wire (green or bare copper) and the bare copper wire from the fixture together. If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
Estimated Assembly Time: 20 minutes
Tools Required For Assembly (not included):
- Flathead screwdriver
- Phillips screwdriver
- Pliers
- Electrical tape and Wire cutters.
Helpful Tools (not included):
- Wire strippers
- Ladder
Note : Press the wire restraint to adjust the desired length of cable.
DESCRIPTION
- A- Outlet Box screw x 2
- B- Black wire(L) from junction box
- C- White wire(N) from junction box
- D- Green wire/Bare copper (G) from junction box
- E- Black wire (L) from fixture
- F- White wire (N) from fixture
- G- Green wire/Bare copper from fixture
- H- Wire connector x 3
THIS LUMINAIRE MUST BE MOUNTED OR SUPPORTED INDEPENDENTLY OF AN OUTLET BOX
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>