EUROfase 35665 Balewood Chrome Bath Bar Instruction Manual
- June 12, 2024
- EUROfase
Table of Contents
EUROfase 35665 Balewood Chrome Bath Bar
Product Information
You have purchased a lighting product that is designed and built to provide
you with years of enjoyment.
Estimated Assembly Time: 20 minutes
Tools Required For Assembly (not included):
- Flathead screwdriver
- Phillips screwdriver
- Pliers
- Electrical tape
- Wire cutters
Helpful Tools (not included):
- Wire strippers
- Ladder
Product Usage Instructions
- Start by gathering all the necessary tools for assembly.
- Identify the following items:
- A-Outlet Box screw x 2
- B-Black wire (L) from junction box
- C-White wire (N) from junction box
- D-Green wire/Bare copper (G) from the junction box
- E-Black wire (L) from the fixture
- F-White wire (N) from the fixture
- G-Green wire/Bare copper from the fixture
- H-Wire connector x 3
- Refer to the user manual for detailed illustrations and instructions on how to connect the wires.
- Use the wire connectors to connect the corresponding wires from the junction box and the fixture.
- Tighten the outlet box screws to secure the fixture in place.
- If necessary, use wire strippers to remove the insulation from the wires before connecting them.
- Ensure that all connections are secure and properly insulated with electrical tape.
- Follow any additional instructions provided in the user manual for mounting or adjusting the lighting product.
Note : It is important to follow all safety precautions and local electrical codes when installing and using this lighting product. If you are unsure or uncomfortable with any step of the assembly process, consult a professional electrician.
Thank You,
You’ve just purchased a lighting product designed and built to provide you
with years of enjoment.
ASSEMBLY INSTRUCTIONS
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
Follow the assembly instructions by reading the numerical progression.
- Use a qualified electrician for installation of this lighting fixture.
- Before installing fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box.
- All electrical connections must be in accordance with local and National Electrical Code or Canadian Electrical Code standards.
- Use CSA or UL listed wire connectors suitable for the gauge, type and number of conductors.
- Attach junction box grounding wire (green or bare copper) and the bare copper wire from the fixture together. If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
Estimated Assembly Time: 20 minutes
Tools Required For Assembly (not included):
- Flathead screwdriver,
- Phillips screwdriver,
- Pliers,
- Electrical tape and
- Wire cutters.
Helpful Tools (not included):
- Wire strippers,
- Ladder
CONNECTING WIRES
4 X 7W MAX,LED,120V,60Hz (Dimmable LED Included)
- A: Outlet Box screw x 2
- B: Black wire(L) from junction box
- C: White wire(N) from junction box
- D: Green wire/Bare copper (G) from the junction box
- E: Black wire (L) from fixture
- F: White wire (N) from fixture
- G: Green wire/Bare copper from the fixture
- H Wire connector x 3
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>