ABYSM GAMING DANUBE SAVA H500 Computer Case User Manual
- June 12, 2024
- ABYSM GAMING
Table of Contents
ABYSM GAMING DANUBE SAVA H500 Computer
Dimension
- Accessory pack
- Wire interface sketch map
- 1/O function introduction
- Chassis display drawing
- Chassis disassembling & Installing
- Motherboard installation
- Power supply installation
- MB 2.5° hard-drive bay, hard drive installation
- Bottom panel 3.5° hard-drive installation
- Bottom panel cooling fan installation
- MB fan position, fan installation
- Rear panel fan installation
- Top panel fan installation
- MB fan position, radiator installation
- Top panel radiator installation
- Rear panel radiator installation
- GPU installation
Specification
Accessory pack
Installation Instruction
Wire interface display drawing
Attention: Positive to positive, negative to negative don’t take it backwards
I/O function introduction
Chassis display diagram
Chassis disassembly and installation
MB installation
Adjust the copper pillar according to different MB models
PSU installation
Install the PSU on the hanger, align it with the hole, lock with screws from outside chassis and secure the PSU Lock the installed hanger back into the chassis Unscrew the screws to remove the PSU and install the shield
MB hard-drive bay 2.5″ card installation
Put in 2.5° hard drive and align it with the hole, secure the hard drive with screws on the back Put the installed hard drive back to the back of MB secure with screws
Bottom panel 3.5″ hard drive installation
Lock the step screws and shock absorbed pad on the hard drive Put the locked hard drive to the bottom panel, align with the holes and push the hard drive into the holes
Bottom panel cooling fan installation
Fan position on bottom panel compatible with 120/140mm cooling fan. Two long fan screws can be locked only Adjust the fan to blow up and align with the holes, lock with long fan screws on the top
MB cooling fan installation
MB fan position supports 3120mm/3140mm cooling fan
Adjust the fan to blow to outside the chassis, align with the holes and lock with screws outside (fan screws are not standard configuration)
Rear panel cooling fan installation
Rear panel support 1*120/140mm cooling fan
Adiust the fan to blow to outside the chassis, align with the holes and lock with screws outside(fan screws are not standard configuration)
Top panel cooling fan installation
Top panel support 3120mm/2140mm cooling fan
Adjust the fan to blow to outside the chassis, align with the holes and lock with screws outside(fan screws are not standard configuration)
MB radiator installation
MB fan bay support 120/240/280/360 radiator(according GPU length) If USB3.0 on the right of MB, it does not support 28 radiator when testing insertion
Top panel radiator installation
Top panel support 120/240/280/360 radiator
Rear panel radiator installation
Rear panel support 120/140 radiator
GPU installation
Take off the PCI field and put the GPU in MAX. GPU length: 430mm
MAX. cooling fan length on MB: 430mm MAX. liquid cooler length: 271mm
MEANING OF THE DUSTBIN SYMBOL
Protect our environment: do not dispose of electrical equipment in your
domestic waste. Please return any electrical equipment that you will no longer
use to the collection points provided for their disposal. These simple steps
can help to avoid the potential effects that incorrect waste disposal can
cause on the environment and human health. This will contribute to recycling
and other forms of re-use of electrical and electronic equipment. Information
concerning where the equipment can be disposed of can be obtained from your
local authorities.
MADE IN CHINA
Imported by: COLORS Information Technology, SL. C/ Morse, 49
Pol. Ind. San Marcos 28906 Getafe (Madrid)
CIF: B-84045574
www.colors-it.es
Please read this manual carefully before using the device. Save the same for future reference
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>