A-iPower GXS11300R Remote Control Portable Generator User Guide
- June 17, 2024
- A-iPOWER
Table of Contents
GXS11300R
MODEL NO.:4592041
Generator Quick Start Guide
GXS11300R Remote Control Portable Generator
Unpack Generator: Remove generator, accessories, inserts and Literature
from carton. If any item is missing or damaged, contact our product service
department at 855-888-3598.
Included Items
WARNING
This Quick Reference Guide is not substitute for reading the operator’s
manual. To reduce the risk of injury or death, user must read and underdstand
the operator’s manual before using this product. All pages references to the
operator’s manual.
-
Install the wheel kit
Slide the axle pin(B) through the wheel(C), flat washer(D) and mount point on the frame(E). Secure them with cotter pin(F),then assemble Cap(A) to Wheel(C).Attach the support leg(H) to the generator frame with flange bolt(G) (M8X16) and tighten. -
Battery cable connection
A quick connect battery plug is pre-installed on the battery. Cut the cable tie securing the plugs and push two halves A and B firmly to connect them. -
Add lubricant and fuel
Use a funnel to pour provided engine oil into engine. Fill to the upper mark of the oil dipstick H.Use clean / fresh regular UNLEADED gasoline with a minimum 87 octane. -
Adjust shock-absorbing seat
Before operating the generator, the shock-absorbing seat (cushion) must be adjusted for proper clearance. Loosen the lock nut and adjust the shock- absorbing seat so there is a 3mm gap between the top of the seat and the bottom of the motor bracket. Re-5tighten the lock nut. -
Start generator
Move generator outside to a flat, level surface, away from doors, windows and vents.
Danger
Using a generator indoors CAN KILL YOU IN MINUTES. Generator exhaust contains
carbon monoxide. This is a poison you cannot see or smell. NEVER use inside a
home or garage, EVEN IF doors and windows are open. Only use OUTSIDE and far
away from windows, doors and vents.
Avoid other generator hazards. READ MANUAL BEFORE USE.
WARNING Do not overload generator or electrical cords. Consult operation
manual.
Add gasoline to the fuel tank. Turn the battery switch to the “ON”(l)
position.
Turn the starting dial switch to the “RUN” position. Remote Start Push
and hold the REMOTE START switch for few seconds until the engine start.
Electric Start Push and hold the ENGINE START/STOP switch for few seconds
until the engine start.
Recoil Start Move the choke
lever to the “START” position.
Pull recoil starter slowly until resistance is felt, then pull rapidly.
Move the choke lever to the “RUN” position. Plug in items to be powered, using
only grounded extension cords.
Shutdown and storage
Remove any load from the generator.
Push STOP on the remote start key fob for 3 seconds.
Push and hold the START/STOP
button for 3 seconds.
Turn off the battery switch to “OFF” position .
Turn the starting dial
switch to the “OFF” position.
If generator is to be stored for longer than 30 days, refer to The operator’s
manual for further Instruction.
Questions? Call855-888-3598 or
emailsupport@a-ipower.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>