ABYSM GAMING 2nd Generation MORPHEO ATX 3.0 750W Power Supply Instruction Manual

ABYSM GAMING 2nd Generation MORPHEO ATX 3.0 750W Power Supply

Warnings and Caution

1. Do not unplug the AC power cord when the power supply is in use. Doing so may cause damage to your components.
2. Do not place the power supply in a high humidity and/or temperature environment.
3. High voltages exist in the power supply. Do not open the power supply case unless you are an authorized service technician or electrician. Doing so will void the warranty.
4. PSU should be powered by the source indicated on the rating label.
5. All warrantees and guarantees will be voided, if failure to comply with any of the warnings and cautions covered in this manual.

Components Check

• Power supplv unit
• User manual
• AC power cord
• Mounting screw × 4
• Cable straps × 4

Power Connector Introduction

Installation Steps

Note: Make sure that your system is turned off and unplugged. Disconnect the AC power cord from your old power supply.

1. Open your computer case; Please refer to the direction in your case manual.

2. Install the PSU into the case with the four screws provided.

3. If your motherboard requires a 24 pin Main Power connector, please connect the 20+4 pin MainPower connector to the motherboard. If your motherboard only requires a 20pin Main Powerconnector, please detach the 4pin connector from the 20+4 pin Main Power connector thenconnect only the 20pin connector to the motherboard.

4. For motherboard that only requires a 4pin AT 12V (CPU) connector, please detach a 4 pinconnector from the 4+4 pin AT 12V connector and connect it to the motherboard. (Either one of the 4 pin from the 4+4 pin ATX 12V connector will work).
   For motherboard that requires a single Spin EPS connector, please use the 4+4 pin connector from the power supply.

5. Connect other peripheral power connectors to devices such as hard drives, optical drives, etc.

6. If your graphic card requires PCI-E power connector, please connect corresponding PC I connector instructed by your graphic card’s user manual. Please note the power supply utilizes an unique pin PCI- connector that can be effectively used as a single Spin or 6 pin PCI-E connector. Touse it as a 6 pin PCI-E connector, please detach the 2 pin connector from the 6+2 pin connector.

7. Close your computer case and connect the AC power cord to the power supply AC inlet.

Output Specification

Total Protection

• Over Voltage Protection
• Short Circuit Protection
  Activated when any DC rails short short circuited.

SAFETY

EMI & SAFETY
UL/CUL, TUV, GOST, CE, FCC and BSMI.

• Over Power Protection
  Protection at 115%-150% full load.

Environments

• Operating temperature: +0°C to +40°C
• Operating humidity: 20% to 90%, non-condensing
• MTBF: > 120,000 hours

MEANING OF THE DUSTBIN SYMBOL
Protect our environment: do not dispose of electrical equipment in your domestic waste. Please return any electrical equipment that you will no longer use to thecollection points provided for their disposal. These simple steps can help to avoidthe potential effects that incorrect waste disposal can cause on the environment and human health. This will contribute to recycling and other forms of re-use of electrical and electronic equipment. Information concerning where the equipment can be disposed of can be obtained from your local authorities.

MADE IN CHINA

• Imported by: COLORS Information Technology, SL.
• C/ Morse, 49 – Pol. Ind. San Marcos • 28906 Getafe (Madrid)
• CIF: B-84045574

www.abysmgaming.com
Please read this manual carefully before using the device. Save it for future reference.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>