Oase LunaLed 6s LunaLED Illuminated Water Jet Heads Instruction Manual
- June 12, 2024
- Oase
Table of Contents
Oase LunaLed 6s LunaLED Illuminated Water Jet Heads
Product Information
The LunaLed series consists of two models: LunaLed 6S and LunaLed 9S. These units are designed for the exclusive purpose of illuminating spring stones. The product comes with a safety transformer and has the following specifications:
| Model | Hose Connection | Light Intensity | Power Consumption | Cable Length |
|---|---|---|---|---|
| LunaLed 6S | 3/4″ (19 mm) | 720 lx | 1.4 W | 10 m |
| LunaLed 9S | 1″ (25 mm) | 780 lx | 1.6 W | 10 m |
The safety transformer provided with the unit operates at a primary voltage of 230 V AC and frequency of 50 Hz, and it outputs a secondary voltage of 12 V DC with a maximum power of 2 VA.
Product Usage Instructions
Installation
- Ensure the unit is installed according to the user manual.
Commissioning/Start-up
- To switch on the unit, turn on the pump and connect the transformer to a socket.
- To switch off the unit, turn off the pump and disconnect the transformer from the socket.
- To regulate the bubbling intensity, either turn the stainless steel cap of the light ring (H) or adjust the connected pump.
Remedy of Faults
If you encounter any issues with the LunaLed unit, refer to the following table for possible causes and remedies:
| Issue | Cause | Remedy |
|---|---|---|
| Lunaled does not light up | No power supply | Check power supply |
| Light intensity decreases | Transformer overheated | Allow transformer to cool |
down
Irregular ‘water’ picture| Light ring defective| Replace light ring (G)
| Light ring soiled| Clean light ring (G)
| Foreign body in Lunaled| Clean pump
| Pump soiled| Clean pump
Storage/Overwintering
If the unit installation is dry, it can be left in place at temperatures below zero.
Spare Parts
For continued safe and reliable operation of the unit, only use original parts from OASE. Visit our website at www.oase- livingwater.com/spareparts for spare parts drawings and availability.
Disposal
Dispose of the unit through the designated return system provided for this purpose.
Safety Transformer
The safety transformer included with the unit is classified as protection class III, and it should only be used with a safety transformer. It is dust tight and can be submerged up to 0.5 m depth. The transformer is also classified as protection class II, providing protection from contact by protection insulation. It is protected against splash water and foreign bodies larger than 1 mm.
Translation of the original Operating Instructions
Information about these operating instructions
Please read and adhere to the contents of these operating instructions. They belong with the unit and must be passed on together with the unit.
Intended use
The Lunaled series, in the following termed unit, is exclusively intended to
illuminate spring stones.
Safety information
- This unit can be used by children aged 8 and above and by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they are supervised or have been instructed on how to use the unit in a safe way and they understand the hazards involved.
- Do not allow children to play with the unit.
- Only allow children to carry out cleaning and user maintenance under supervision.
The combination of water and electricity can lead to danger to life and limb,
if the unit is incorrectly connected or misused.
Attention! Danger of electric shock. Ensure that the cable connection
points and their surroundings are dry.
The transformer and the plug connectors of the power cables supplied are not
water-tight, but only rain and splash-proof. Do not route or fit in the water.
Protect the plug connection from moisture. The safety transformer must have a
minimum distance to the pond edge of 2 m. Protect the connection cable when
burying to avoid damage. Only use cables approved for outside use. Ensure that
the power connection cable cross section is not smaller than that of the
rubber sheath with the identification H05RN-F. Extension cables must meet DIN
VDE 0620. Only use unwound cables. Electrical installations in garden ponds
and swimming ponds must meet the national and international regulations valid
for installers. Compare the electrical data of the supply with those on the
unit type plate. This data must coincide.
Never operate the unit if the cable or housing are defective! Disconnect the
power! Do not carry or pull the unit by the connection cable.
Only use the unit with the attendant safety transformer contained in our scope
of delivery. Never open the unit housing or its attendant components, unless
this is explicitly mentioned in the operating instructions. Always disconnect
the power supply of all units located in water and of this unit prior to
performing work on the unit! For your own safety, consult a qualified
electrician if you have questions or encounter problems!
Installation
Sensitive electrical components.
Possible consequences: The device will be destroyed.
Protective measure: Do not connect the unit to a dimmable power supply.
Important: Keep a safety distance between transformer and water (A).
- Drill through the spring stone (B).
- Only for Lunaled 9: A dapt the diameter of the hose connector (C).
- Open hose connector (D).
- Lead connection cable (1) through the hose (2) up to the cable outlet in the hose connector (E), then connect hose (2).
- Insert the light ring into the spring stone hole from above (E).
- Insert seal (3) and close hose connector (4).
- Connect hose (5) to hose connector and pump.
- At the transformer, secure the connection cable using the union nut (F).
Commissioning/start-up
Switching on: Switch on pump. Connect transformer to socket.
Switching off: Switch off pump. Disconnect transformer from socket.
Regulate bubbling intensity: Turn stainless steel cap of the light ring
(H) or regulate connected pump.
Remedy of faults
| Malfunction | Cause | Remedy |
|---|---|---|
| Lunaled does not light up | No power supply | Check power supply |
| Transformer overheated | Allow transformer to cool down | |
| Transformer defective | Replace transformer | |
| Light ring defective | Replace Lunaled | |
| Light intensity decreases | Light ring soiled | Clean light ring (G) |
| Irregular ‘water’ picture | Foreign body in Lunaled | Clean light ring (G) |
| Pump soiled | Clean pump |
Storage/overwintering
When the unit installation is dry, it can remain in place at temperatures below zero.
Spare parts
The use of original parts from OASE ensures continued safe and reliable
operation of the unit.
Please visit our website for spare parts drawings and spare parts.
Disposal
NOTE
Do not dispose of this unit with domestic waste.
- Render the unit unusable beforehand by cutting the cables and dispose of the unit via the return system provided for this purpose.
| Hose connection| Light intensity| Power consumption| Cable length| Safety
transformer
---|---|---|---|---|---
Lunaled 6S| 3/4 ” (19 mm)| 720 lx| 1.4 W| 10 m| Pri.: 230 V AC, 50 Hz
Sec. : 12 V DC, max. 2 VA
Lunaled 9S| 1 ” (25 mm)| 780 lx| 1.6 W| 10 m
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>