EUROfase 31440-011 Sonic Chrome Bath Bar Instruction Manual
- June 12, 2024
- EUROfase
Table of Contents
EUROfase 31440-011 Sonic Chrome Bath Bar
Product Information
Product Code: 31440-011
Product Name: Lighting Product
Description: This lighting product is designed and built to provide years of enjoyment. It includes a dimmable LED for optimal lighting control.
Specs:
- Power: 4x6W
- Voltage: 120V
- Frequency: 60Hz
- LED Type: Dimmable LED
Product Usage Instructions
Estimated Assembly Time: 20 minutes
Tools Required For Assembly (not included):
- flathead screwdriver
- Phillips screwdriver
- Pliers
- electrical tape
- wire cutters
Helpful Tools (not included):
- wire strippers
- Leaderboard
Assembly Steps:
- Locate the outlet box in the desired installation area.
- Using a flathead screwdriver, secure the product to the outlet box using the A-Outlet Box screws (x2).
- Connect the wires from the junction box to the fixture as follows:
- B-Black wire (L) from junction box to E-Black wire (L) from fixture.
- C-White wire (N) from junction box to F-White wire (N) from fixture.
- D-Green wire/Bare copper (G) from junction box to G-Green wire/Bare copper from fixture.
- Secure the wire connections using the H-Wire connectors (x3).
- Ensure all connections are properly insulated with electrical tape.
- Once assembled, test the product by turning on the power supply.
For future reference, please save these instructions.
Thank You
You’ ve just purchased a lighting product designed and built to provide you
with years of enjoment.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
- Follow the assembly instructions by reading the numerical progression.
- Use a qualified electrician for installation of this lighting fixture.
- Before installing fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box.
- All electrical connections must be in accordance with local and National Electrical Code or Canadian Electrical Code standards.
- Use CSA or UL listed wire connectors suitable for the gauge, type and number of conductors.
- Attach junction box grounding wire (green or bare copper) and the bare copper wire from the fixture together. If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
Estimated Assembly Time: 20 minutes
Tools Required For Assembly (not included): Flathead screwdriver, Phillips
screwdriver, Pliers, Electrical tape and Wire cutters.
Helpful Tools (not included): Wire strippers, Ladder
4x6W MAX LED 120V 60Hz (Dimmable LED included)
- A- Outlet Box screw x 2
- B- Black wire(L) from junction box
- C- White wire(N) from junction box
- D- Green wire/Bare copper (G) from junction box
- E- Black wire (L) from fixture
- F- White wire (N) from fixture
- G- Green wire/Bare copper from fixture
- H- Wire connector x 3