Eurofase 35655 Cambridge 3 Light Bath Bar Instruction Manual
- June 12, 2024
- EUROfase
Table of Contents
Eurofase 35655 Cambridge 3 Light Bath Bar
Product Information
| Component | Description |
|---|---|
| A | Outlet Box screw x 2 |
| B | Black wire (L) from junction box |
| C | White wire (N) from junction box |
| D | Green wire/Bare copper (G) from junction box |
| E | Black wire (L) from fixture |
| F | White wire (N) from fixture |
| G | Green wire/Bare copper from fixture |
| H | Wire connector x 3 |
Product Usage Instructions
- Ensure you have the following tools for assembly (not included):
- Flathead screwdriver
- Phillips screwdriver
- Pliers
- Electrical tape
- Wire cutters
- Optional helpful tools (not included):
- Wire strippers
- Ladder
- Estimated assembly time: 20 minutes
- Follow the steps below to assemble the product:
- Attach the outlet box screws (A) to the designated spots on the product.
- Connect the black wire (L) from the junction box (B) to the corresponding black wire (L) from the fixture (E). Use a wire connector (H) to secure the connection.
- Connect the white wire (N) from the junction box (C) to the corresponding white wire (N) from the fixture (F). Use a wire connector (H) to secure the connection.
- Connect the green wire/bare copper (G) from the junction box (D) to the corresponding green wire/bare copper from the fixture (G). Use a wire connector (H) to secure the connection.
- Ensure all connections are properly secured and insulated with electrical tape if necessary.
Note: If you encounter any difficulties during assembly or have further questions, please refer to the saved instructions for future reference or contact our customer support.
Thank You
You’ ve just purchased a lighting product designed and built to provide you
with years of enjoment.
INSTALLATION INSTRUCTION
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
-
Follow the assembly instructions by reading the numerical progression.
-
Use a qualified electrician for installation of this lighting fixture.
-
Before installing fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box.
-
All electrical connections must be in accordance with local and National Electrical Code or Canadian Electrical Code standards.
-
Use CSA or UL listed wire connectors suitable for the gauge, type and number of conductors.
-
Attach junction box grounding wire (green or bare copper) and the bare copper wire from the fixture together. If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
-
Estimated Assembly Time: 20 minutes
-
Tools Required For Assembly (not included): Flathead screwdriver, Phillips screwdriver, Pliers, Electrical tape and Wire cutters.
-
Helpful Tools (not included): Wire strippers, Ladder
-
3 X 7.5W MAX,LED,120V,60Hz
- (Dimmable LED Included)
Dimension
- A -Outlet Box screw x 2
- B -Black wire(L) from junction box
- C -White wire(N) from junction box
- D -Green wire/Bare copper (G) from junction box
- E -Black wire (L) from fixture
- F -White wire (N) from fixture
- G -Green wire/Bare copper from fixture
- H -Wire connector x 3
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>