EURofase 38156 Campisi 3 Light Semi Flush Mount Instruction Manual
- June 12, 2024
- EUROfase
Table of Contents
EURofase 38156 Campisi 3 Light Semi Flush Mount
Thank You
You’ ve just purchased a lighting product designed and built to provide you
with years of enjoyment.
Product Information
This lighting product is designed to provide you with years of enjoyment. It requires an assembly time of approximately 20 minutes. The product is compatible with 3 bulbs of maximum 60W each, type B10, with a voltage of 120V and frequency of 60Hz. Please note that bulbs are not included with the product.
Product Usage Instructions
- Before starting the assembly, make sure you have the following tools: Flathead screwdriver, Phillips screwdriver, Pliers, Electrical tape, and Wire cutters. Additional helpful tools include Wire strippers and a Ladder.
- Identify the components:
- A – Outlet Box screw x 2
- B – Black wire (L) from junction box
- C – White wire (N) from junction box
- D – Green wire/Bare copper (G) from junction box
- E – Black wire (L) from fixture
- F – White wire (N) from fixture
- G – Green wire/Bare copper from fixture
- H – Wire connector x 3
- Follow the assembly instructions provided in the manual to connect the various components together. Use the screws and wire connectors as indicated.
- Once the assembly is complete, connect the lighting product to a power source.
- If necessary, adjust the position of the lighting product to achieve the desired illumination.
- If any maintenance or troubleshooting is required, refer to the manual for further instructions.
- Enjoy your new lighting product!
Please note that it is important to save these instructions for future reference.
INSTRUCTIONS
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
- Follow the assembly instructions by reading the numerical progression.
- Use a qualified electrician for installation of this lighting fixture.
- Before installing fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box.
- All electrical connections must be in accordance with local and National Electrical Code or Canadian Electrical Code standards.
- Use CSA or UL listed wire connectors suitable for the gauge, type and number of conductors.
- Attach junction box grounding wire (green or bare copper) and the bare copper wire from the fixture together. If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
Estimated Assembly Time: 20 minutes
Tools
Tools Required For Assembly (not included): Flathead screwdriver,
Phillips screwdriver, Pliers, Electrical tape and Wire cutters.
Helpful Tools (not included): Wire strippers, Ladder
3 X 60W MAX,B10,120V,60Hz (Bulb not included)
INSTALLATION
- A- Outlet Box screw x 2
- B- Black wire(L) from junction box
- C- White wire(N) from junction box
- D- Green wire/Bare copper (G) from junction box
- E- Black wire (L) from fixture
- F -White wire (N) from fixture
- G- Green wire/Bare copper from fixture
- H- Wire connector x 3
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>