Eurofase 31439-015 Sonic Chrome Bath Bar Instruction Manual
- June 12, 2024
- EUROfase
Table of Contents
Eurofase 31439-015 Sonic Chrome Bath Bar
Product Information:
Product Name: Lighting Product
Model Number: 31439-015
Power Supply: 120V 60Hz
Maximum LED Wattage: 3x6W
Dimmable: Yes
Product Usage Instructions
- Estimated Assembly Time: 20 minutes
- Tools Required For Assembly (not included):
- Flathead screwdriver
- Phillips screwdriver
- Pliers
- Electrical tape
- Wire cutters
- Helpful Tools (not included):
- Wire strippers
- Ladder
- Follow the steps below for installation:
- Attach the product to an outlet box using the provided screws (A).
- Connect the black wire (L) from the junction box (B) to the black wire (L) from the fixture (E) using a wire connector (H).
- Connect the white wire (N) from the junction box (C) to the white wire (N) from the fixture (F) using a wire connector (H).
- Connect the green wire/bare copper (G) from the junction box (D) to the green wire/bare copper from the fixture (G) using a wire connector (H).
- Repeat steps b, c, and d for any additional wires.
- Once all connections are made, secure the wire connectors (H) properly.
- If dimming functionality is desired, ensure that the included dimmable LED is properly installed.
- Refer to the user manual for any additional information or troubleshooting.
31439-015
INSTRUCTION MANUAL
MODE
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
- Follow the assembly instructions by reading the numerical progression.
- Use a qualified electrician for installation of this lighting fixture.
- Before installing fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box.
- All electrical connections must be in accordance with local and National Electrical Code or Canadian Electrical Code standards.
- Use CSA or UL listed wire connectors suitable for the gauge, type and number of conductors.
- Attach junction box grounding wire (green or bare copper) and the bare copper wire from the fixture together. If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
Estimated Assembly Time: 20 minutes
Tools Required For Assembly (not included): Flathead screwdriver, Phillips
screwdriver, Pliers, Electrical tape and Wire cutters.
Helpful Tools (not included): Wire strippers, Ladder
ASSEMBLY
3x6W MAX LED 120V 60Hz (Dimmable LED included)
- A- Outlet Box screw x 2
- B- Black wire(L) from junction box
- C- White wire(N) from junction box
- D- Green wire/Bare copper (G) from junction box
- E- Black wire (L) from fixture
- F- White wire (N) from fixture
- G- Green wire/Bare copper from fixture
H- Wire connector x 3
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>