EURofase 38268 Bevelo 5 Light Round Chandelier Instruction Manual
- June 12, 2024
- EUROfase
Table of Contents
EURofase 38268 Bevelo 5 Light Round Chandelier
Product Usage Instructions
Please follow the steps below to assemble and install your lighting product:
- Identify the following items:
- A-Outlet Box screw x 2
- B-Black wire(L) from junction box
- C-White wire(N) from junction box
- D-Green wire/Bare copper (G) from junction box
- E-Black wire from fixture
- F-White wire from fixture
- G-Green wire/Bare copper from fixture
- H-Wire connector x 3
- Using a flathead screwdriver or a Phillips screwdriver, attach the outlet box screws (A) to the appropriate holes in the junction box.
- Connect the black wire (B) from the junction box to the black wire (E) from the fixture using a wire connector (H).
- Connect the white wire (C) from the junction box to the white wire (F) from the fixture using another wire connector (H).
- Connect the green wire/bare copper (D) from the junction box to the green wire/bare copper (G) from the fixture using the remaining wire connector (H).
- Securely tighten all wire connectors.
- Use electrical tape to wrap any exposed wire ends for safety.
- Follow any additional instructions provided in the user manual for mounting and securing the lighting product.
Instructions
Thank You
You’ ve just purchased a lighting product designed and built to provide you with years of enjoyment.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
- Follow the assembly instructions by reading the numerical progression.
- Use a qualified electrician for installation of this lighting fixture.
- Before installing fixture disconnect power by turning the circuit breaker or by removing the fuse at the fuse box.
- All electrical connections must be in accordance with local and National Electrical Code or Canadian Electrical Code standards.
- Use CSA or UL listed wire connectors suitable for the gauge, type and number of conductors.
- Attach junction box grounding wire (Green or Bare Copper) and the Bare Copper wire from the fixture together. If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
Estimated Assembly Time: 20 minutes
Tools Required
Tools Required For Assembly (not included)
- Flathead screwdriver,
- Phillips screwdriver,
- Pliers,
- Electrical tape and Wire cutters.
Helpful Tools (not included)
- Wire strippers,
- Ladder
5 X 60W MAX,T45,120V,60Hz
(Bulbs not included)
Using Instructions
- A- Outlet Box screw x 2
- B- Black wire(L) from junction box
- C- White wire(N) from junction box
- D- Green wire/Bare copper (G) from junction box
- E- Black wire from fixture
- F- White wire from fixture
- G- Green wire/Bare copper from fixture
- H- Wire connector x 3
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>