Eurofase 36249 Crossroads LED Flush Mount Instruction Manual
- June 12, 2024
- EUROfase
Table of Contents
Eurofase 36249 Crossroads LED Flush Mount
Product Information
You have purchased a lighting product that consists of 9 x 1W MAX LED lights, designed to operate at 120V and 60Hz. The LED lights included in the package are dimmable.
Product Usage Instructions
- Estimated Assembly Time: 20 minutes
- Tools Required For Assembly (not included):
- Flathead screwdriver
- Phillips screwdriver
- Pliers
- Electrical tape
- Wire cutters
- Helpful Tools (not included):
- Wire strippers
- Ladder
- Follow the steps below to assemble and install the lighting product:
- Secure the lighting fixture to the outlet box using the provided A-Outlet Box screws (x2).
- Connect the Black wire (L) from the junction box to the Black wire (L) from the fixture (E) using one of the Wire connectors (H).
- Connect the White wire (N) from the junction box to the White wire (N) from the fixture (F) using another Wire connector (H).
- Connect the Green wire/Bare copper (G) from the junction box to the Green wire/Bare copper from the fixture (G) using a third Wire connector (H).
Please note that these instructions are a simplified version. For detailed and specific instructions, refer to the complete user manual included with the product.
Thank You
You’ ve just purchased a lighting product designed and built to provide you
with years of enjoment.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
- Follow the assembly instructions by reading the numerical progression.
- Use a qualified electrician for installation of this lighting fixture.
- Before installing fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box.
- All electrical connections must be in accordance with local and National Electrical Code or Canadian Electrical Code standards.
- Use CSA or UL listed wire connectors suitable for the gauge, type and number of conductors.
- Attach junction box grounding wire (green or bare copper) and the bare copper wire from the fixture together. If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
- Estimated Assembly Time: 20 minutes
- Tools Required For Assembly (not included): Flathead screwdriver, Phillips screwdriver, Pliers, Electrical tape and Wire cutters.
- Helpful Tools (not included): Wire strippers, Ladder
9 x 1W MAX LED,120V,60HZ
(Dimmable LED included)
- A- Outlet Box screw x 2
- B- Black wire(L) from junction box
- C- White wire(N) from junction box
- D- Green wire/Bare copper (G) from junction box
- E- Black wire (L) from fixture
- F- White wire (N) from fixture
- G- Green wire/Bare copper from fixture
- H- Wire connector x 3
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>