Eurofase 37070 Ryder 4 Light Bath Bar Instruction Manual
- June 12, 2024
- EUROfase
Table of Contents
Eurofase 37070 Ryder 4 Light Bath Bar
Product Information
You have just purchased a lighting product designed and built to provide you with years of enjoyment.
Estimated Assembly Time:
- 20 minutes
Tools Required For Assembly (not included):
- Flathead screwdriver
- Phillips screwdriver
- Pliers
- Electrical tape
- Wire cutters
Helpful Tools (not included):
- Wire strippers
- Ladder
Product Usage Instructions
Before starting the assembly process, please make sure you have read and understood the following instructions:
- Identify the different components:
- A-Outlet Box screw x 2
- B-Black wire(L) from junction box
- C-White wire(N) from junction box
- D-Green wire/Bare copper (G) from junction box
- E-Black wire (L) from fixture
- F-White wire (N) from fixture
- G-Green wire/Bare copper from fixture
- H-Wire connector x 3
- Follow the step-by-step assembly instructions provided in the user manual.
- Use the required tools to complete the assembly process:
- Flathead screwdriver
- Phillips screwdriver
- Pliers
- Electrical tape
- Wire cutters
- If needed, use the helpful tools:
- Wire strippers
- Ladder
Please note that these instructions are for reference only. Always refer to the user manual provided with the product for detailed and accurate information.
Thank You
You’ ve just purchased a lighting product designed and built to provide you
with years of enjoment.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
- Follow the assembly instructions by reading the numerical progression.
- Use a qualified electrician for installation of this lighting fixture.
- Before installing fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box.
- All electrical connections must be in accordance with local and National Electrical Code or Canadian Electrical Code standards.
- Use CSA or UL listed wire connectors suitable for the gauge, type and number of conductors.
- Attach junction box grounding wire (green or bare copper) and the bare copper wire from the fixture together. If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
- Estimated Assembly Time: 20 minutes
- Tools Required For Assembly (not included): Flathead screwdriver, Phillips screwdriver, Pliers, Electrical tape and Wire cutters.
- Helpful Tools (not included): Wire strippers, Ladder
4-LIGHT 20W MAX 120V,60Hz
(Dimmable LED Included)
- A- Outlet Box screw x 2
- B- Black wire(L) from junction box
- C- White wire(N) from junction box
- D- Green wire/Bare copper (G) from junction box
- E- Black wire (L) from fixture
- F- White wire (N) from fixture
- G- Green wire/Bare copper from fixture
- H- Wire connector x 3
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>