Eurofase 37069 Ryder 3 Light Bath Bar Instruction Manual
- June 12, 2024
- EUROfase
Table of Contents
Eurofase 37069 Ryder 3 Light Bath Bar
Product Information
You have just purchased a lighting product that is designed and built to
provide you with years of enjoyment.
Estimated Assembly Time: 2 0 minutes
Tools Required For Assembly (not included):
- Flathead screwdriver
- Phillips screwdriver
- Pliers
- Electrical tape
- Wire cutters
Helpful Tools (not included):
- Wire strippers
- Ladder
Product Usage Instructions
- Locate the outlet box where you want to install the lighting product.
- Using a flathead screwdriver, secure the A-Outlet Box screws (x2) to fix the lighting product in place.
- Identify the wires from the junction box:
- B-Black wire (L)
- C-White wire (N)
- D-Green wire/Bare copper (G)
- Connect the wires from the junction box to the fixture:
- E-Black wire (L) from the fixture to the B-Black wire (L) from the junction box.
- F-White wire (N) from the fixture to the C-White wire (N) from the junction box.
- G-Green wire/Bare copper from the fixture to the D-Green wire/Bare copper (G) from the junction box.
- Secure the connections using wire connectors (H-Wire connector x3).
Thank You
You’ ve just purchased a lighting product designed and built to provide you
with years of enjoment.
INSTALLATION INSTRUCTION
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
- Follow the assembly instructions by reading the numerical progression.
- Use a qualified electrician for installation of this lighting fixture.
- Before installing fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box.
- All electrical connections must be in accordance with local and National Electrical Code or Canadian Electrical Code standards.
- Use CSA or UL listed wire connectors suitable for the gauge, type and number of conductors.
- Attach junction box grounding wire (green or bare copper) and the bare copper wire from the fixture together. If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
- Estimated Assembly Time: 20 minutes
- Tools Required For Assembly (not included): Flathead screwdriver, Phillips screwdriver, Pliers, Electrical tape and Wire cutters.
- Helpful Tools (not included): Wire strippers, Ladder
- 3-LIGHT 13W MAX 120V, 60Hz
- (Dimmable LED Included)
Dimension
- A -Outlet Box screw x 2
- B -Black wire(L) from junction box
- C -White wire(N) from junction box
- D -Green wire/Bare copper (G) from junction box
- E -Black wire (L) from fixture
- F -White wire (N) from fixture
- G -Green wire/Bare copper from fixture
- H -Wire connector x 3
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>