Eurofase 35657-019 Cambridge 5 Light Bath Bar Instructions
- June 12, 2024
- EUROfase
Table of Contents
Eurofase 35657-019 Cambridge 5 Light Bath Bar
Product Information
You have purchased a lighting product that is designed to provide you with years of enjoyment. The product specifications are as follows:
- Model Number: 35657
- Power: 5 x 7.5W MAX
- LED Type: Dimmable LED
- Voltage: 120V
- Frequency: 60Hz
Product Usage Instructions
Before starting the assembly, please make sure you have the following tools ready:
- Flathead screwdriver
- Phillips screwdriver
- Pliers
- Electrical tape
- Wire cutters
Additionally, the following tools may be helpful but are not required:
- Wire strippers
- Ladder
Estimated Assembly Time: 20 minutes
Follow the steps below to assemble and install the lighting product:
- Locate the outlet box and ensure it is securely mounted.
- Using a screwdriver, attach the A-Outlet Box screws (x2) to the outlet box.
- Identify the Black wire (L) from the junction box and connect it to the B terminal on the lighting fixture.
- Identify the White wire (N) from the junction box and connect it to the C terminal on the lighting fixture.
- Identify the Green wire or Bare copper wire (G) from the junction box and connect it to the D terminal on the lighting fixture.
- Identify the Black wire (L) from the lighting fixture and connect it to the E terminal on the lighting fixture.
- Identify the White wire (N) from the lighting fixture and connect it to the F terminal on the lighting fixture.
- Identify the Green wire or Bare copper wire from the lighting fixture and connect it to the G terminal on the lighting fixture.
- Securely fasten the connections with wire connectors (x3).
Please refer to these instructions whenever you need to consult them in the future. If you have any further questions or need assistance, please contact our customer support.
Thank You
You’ ve just purchased a lighting product designed and built to provide you
with years of enjoment.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
- Follow the assembly instructions by reading the numerical progression.
- Use a qualified electrician for installation of this lighting fixture.
- Before installing fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box.
- All electrical connections must be in accordance with local and National Electrical Code or Canadian Electrical Code standards.
- Use CSA or UL listed wire connectors suitable for the gauge, type and number of conductors.
- Attach junction box grounding wire (green or bare copper) and the bare copper wire from the fixture together. If junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
- Estimated Assembly Time: 20 minutes
- Tools Required For Assembly (not included): Flathead screwdriver, Phillips screwdriver, Pliers, Electrical tape and Wire cutters.
- Helpful Tools (not included): Wire strippers, Ladder
- A- Outlet Box screw x 2
- B- Black wire(L) from junction box
- C- White wire(N) from junction box
- D- Green wire/Bare copper (G) from junction box
- E- Black wire (L) from fixture
- F- White wire (N) from fixture
- G- Green wire/Bare copper from fixture
- H- Wire connector x 3
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>