motogadget MSM-Combi Frame with Indicator Lights Instruction Manual
- June 12, 2024
- motogadget
Table of Contents
motogadget MSM-Combi Frame with Indicator Lights Instruction Manual
EXCLUSION OF LIABILITY
INSTRUMENT HOUSINGS AND ALL OTHER DELIVERED PARTS MUST NOT BE OPENED OR
DISMANTLED. IN CASE OF NONCOMPLIANCE ALL GUARANTEE CLAIMS BECOME INVALID.
MOTOGADGET ACCEPTS NO LIABILITY FOR DIRECT OR INDIRECT DAMAGE OR SUBSEQUENT
DAMAGE OF ANY KIND RESULTING FROM THE USE, INSTALLATION OR CONNECTION OF
INSTRUMENTS, THE SENSORS OR OTHER DELIVERED EQUIPMENT. THIS EXCLUSION OF
LIABILITY PARTICULARLY INCLUDES DAMAGE TO PERSONS, MATERIAL LOSSES AND
FINANCIAL DAMAGES. THE USE OF THE HANDLEBAR TOP CLAMP IN AREAS OF PUBLIC
TRAFFIC IS UNDERTAKEN AT THE USER’S OWN RISK.
Installation
MSM-Combi features 5 indicator lights. It allows to installing the motoscope mini in following ways:
Handlebar mount with cables inside for 22mm and 1″ diameter
– hold the rear plate at the desired handle bar position and mark two holes
for cables and two holed for the mounting screws
– drill two holes with 2,4mm diameter and tap a M3 thread
– drill both cable holes with 6mm drill and remove burr, tape the edges with
textile tape
– thread the MSM-Combi cable trough the handle bar and mount the housing with
two M3 screws
– thread the motoscope mini cable trough the handle bar, insert the instrument
and clamp it with a M3 stud screw.
Handlebar mount with cables outside for 22mm and 1″ diameter
Mount on the universal bracket (bracket can be drilled, bend or cut)
Installation with a weld-in-housing for a fuel tank integration
– weld a stainless steel tube (inner dia. 10mm, leght = fuel tank height) at
the cable outlet on the backside of the weld-inhousing.
– make a cut out in the shape of the weld-in-housing at the topside of the
fuel tank.
– drill a hole with diameter of the steel tube in the opposite fuel tank
bottom
– weld the weld-in-housing together with the cut out at the fuel tank – weld
the tube with the hole at the bottom side
– check the leak tightness / paint
– mount the MSM-Combi housing into the weld-in-housing by two M3 screws
– thread the motoscope cable trough the tube and install the instrument with a
small amount of silicone rubber into the weld-in- housing
Electrical connection
Remove the vehicle battery before continuing the electrical wiring or interrupt the connection to the onboard power supply. Then connect the warning lights as follows:
To join both sides of turn signals together to one turn control lamp the
please refer as the schematic below.
Declaration of Conformity
Hereby, motogadget GmbH declares the product is in compliance to EU
directives. The full text of the EU Declaration of Conformity is available at
the following internet address:
https://manuals.motogadget.com/motoscope-mini-combiframe
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>