anko 42967859 Metal Wooden Gate Instruction Manual
- June 17, 2024
- Anko
Table of Contents
Metal & Wooden Gate
Instruction Manual
42967859 Metal Wooden Gate
THE ILLUSTRATIONS SHOWN IN THIS MANUAL ARE FOR REFERENCE ONLY. THE
MANUFACTURER RESERVES THE RIGHT TO CHANGE ANY SPECIFICATION OR FEATURE WITHOUT
FURTHER NOTICE.
IMPORTANT! READ AND FOLLOW THESE INSTRUCTIONS CAREFULLY AND KEEP FOR
FUTURE REFERENCE CONFORMS TO EN 1930:2011
IMPORTANT! READ AND FOLLOW THESE INSTRUCTIONS CAREFULLY AND KEEP FOR FUTURE REFERENCE
Introduction
Please read the instructions thoroughly to ensure proper installation. Please immediately inspect the safety gate upon receipt. If you see any damage, do not assemble gate and please go to back page of the instruction booklet for website or Consumer Relations Representative information. Adult assembly required and keep away from children, due to small components and choking hazard.
Important Information
There is a gap between the gate frame and handle. This is not a defect. The
gap on the gate will close once it is properly mounted.
Please check the gate on a regular basis to ensure gate and parts are all in
proper working order. If the gate is used at top of stairs, it must be placed
on the landing above the top stair. When using at top of stairs, gate must
open away from stairs. If the gate is used at the bottom of the stairs, please
place towards the front of the lowest stair. The safety barrier must not be
fitted across windows. Ensure gate is attached between two clean and
structurally sound surfaces. Ensure appropriate fixings are used for drywall,
wood, brick, etc. If wall plugs provided with the gate do not secure to the
wall satisfactorily, consult with a hardware store for the suitable wall plug
application. If additional parts are required for this gate, please go to back
page of the instruction booklet for website or Consumer Relations
Representative information. Do not use this gate at top or bottom of stairs
without using all four wall cups. For maximum safety, use four Wall Cups with
Sticky Pads and Screws when installing the gate in all locations. In some
openings, only two top wall cups can be fitted.
Disclaimer
Any safety gate which has been subjected to misuse, abuse, abnormal use,
excessive wear and tear, improper assembly, negligence, environmental
exposure, alteration or accident, or has had its serial number altered or
removed invalidates any/all claims against
the manufacturer. Any damage to property during installation of the safety
gate is the sole responsibility of the end user.
WARNING!
WARNING – To prevent serious injury or death, securely install gate or
enclosure and use according to manufacturer’s instructions.
WARNING – Never leave child unattended when using this product.
WARNING – Incorrect installation can be dangerous.
WARNING – Do not use the safety barrier if any components are damaged or
missing.
WARNING – The safety barrier must not be fitted across windows.
WARNING – Never use with a child able to climb over or dislodge/open the
safety barrier, which may cause danger.
WARNING – Never install this product on glass doors. Install this product
against reliable doors or walls.
WARNING – If the safety barrier is used at the bottom of the stairs, it
should be positioned at the front of the lowest tread possible.
WARNING – To prevent injury, do not put any goods which can be grabbed by
children or pets near this product.
WARNING – Before using this product, carefully inspect for any loose
parts and whether any parts need to be tightened.
WARNING – Make sure the product to be installed is horizontal and flat on
the floor.
WARNING – This product is intended for use with children from 6 to 24
months or small to medium pets.
WARNING – Regularly check that the safety barrier is properly installed
and secure.
WARNING – Any additional or replacement parts should be obtained from
Kmart Australia Ltd.
WARNING – Barrier must be fitted between rigid surfaces such as plaster
board, timber or hardwall.
WARNING – Always check that the safety barrier is correctly closed.
WARNING – Use only with the locking/latching mechanism securely engaged.
WARNING – This safety barrier is for domestic use only.
WARNING – Never use without wall cups.
WARNING – This safety barrier has a manual closing system.
WARNING – This safety barrier must be fitted between a rigid surface such
as doorways or walls along with wall cups secured with screws.
If the safety barrier is used at the bottom of the stairs, it should be
positioned at the front of the lowest tread possible.| If the safety barrier
is used at the top of the stairs, it should not be positioned below the top
level.
---|---
Push all the way into the square tube. 
Screw mounting bolts and adjuster screws together and then place
into mounting holes in each corner of the gate.
IMPORTANT: Gate must be installed in a structurally sound opening. Ensure
mounting surface (wall, door frame, stair posts, etc.) is strong, rigid and
has an even surface.
Place the gate in the opening and ensure the bottom rail is completely flat on the floor and the wall cups are directly above each other. Then mark the position of each wall cup on the wall and stick the cups in position using the adhesive pads. For added security, fix each cup to the wall using a small Phillips head screwdriver (not included) and screws provided. Align gate with wall cups and tighten adjuster screws by turning clockwise, starting with the bottom and then the top. Tighten equally until there is only a 1mm gap in the locking mechanism. Regularly check tension of all mounting bolts and adjust if required.
PLEASE NOTE: The gate should be resting on the floor.
If there is a gap, it must be less than 5mm between the gate and floor.
When you unpack the gate, you may notice a gap at the gate opening – this is normal with pressure mounted gates and the gap will disappear when it is installed correctly.
With part G in neutral position, the gate will open in both directions. However when engaging part G, it will act as a stopper and the gate will only be able to open in one direction.
Keycode 42967859
MADE IN CHINA
FOR AU / NZ: IMPORTED FOR KMART
STORES IN AUSTRALIA AND NEW ZEALAND.
KMART CUSTOMER SERVICE
AU: 1800 124 125 NZ: 0800 945 995
https://manual-hub.com/
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>