AVANTCO 194SQRCGF Countertop Glass Froster or Chiller User Manual
- June 12, 2024
- AVANTCO
Table of Contents
Countertop Glass
Froster/Chiller
Model: 194SQRCGF
Please read the manual thoroughly prior to equipment setup, operation, and maintenance.
Warning and Safety
WARNING : This product works with liquid CO2 only, do not use other compressed gas cylinders with high-pressure or non-liquid CO2. A liquid CO2 cylinder with siphon tube is recommended for effective delivery of liquid CO2. A non-liquid CO2 cylinder may be used if the tank is inverted (turned upside down). Install this product in a well-ventilated area to assist in venting excess CO2.
Setup and Operating
- Connect the glass froster with CO2 tank and make sure there is no gas leak.
- Slowly open CO2 tank, ensuring no leaks in the system, then fully open CO2 tank.
- Connect the glass froster with the power.
- Press the blue-red button to turn on the machine.
- Prepare the glasses.
- Press on the blue button to ensure equipment is operational.
Replacing CO2 Cylinder:
When frosting time exceeds 10 seconds, this is an indication that it is time
to change the cylinder.
-
Close the shut-off valve of the CO2 cylinder.
-
Press the blue button of the glass froster until all excess pressure is released.
-
Loosen the nut on the CO2 cylinder and remove the CO2 cylinder.
-
Replace with full CO2 cylinder.
-
Place steel wire for connection hose around the CO2 tank.
-
Add rubber seal rings to inside of connection hose nut, then connect to CO2 tank.
-
Tighten using hands, then use a wrench to tighten.
NOTE : Do not overtighten. -
Slowly open CO2 tank, ensuring no leaks in the system, then fully open CO2 tank.
-
Press down on the blue button to ensure equipment is operational.
Troubleshooting
| PROBLEM | SOLUTION |
|---|---|
| Long frosting time | Replace the CO2 tank with a full tank. |
| Not frosting at all | Replace the CO2 tank with a full tank. |
This unit requires a CO2 tank with a siphon tube.
