celly PCBHSTEREO Bluetooth Stereo Earphones User Manual
- June 4, 2024
- celly
Table of Contents
celly PCBHSTEREO Bluetooth Stereo Earphones
Read this user manual and in particular the safety notes, before using the product. Keep the user manual for future reference and include it when passing the product on to third parties. Celly S.p.A. will not in any way be held responsible for injury or damage caused to persons or property arising from misuse of the product.
Safety notes
Avoid listening at extreme volumes, particularly for prolonged periods of time
when using the product. If you use the product at an excessively high volume,
you could permanently damage your hearing. Listen at a moderate volume.
Audio warnings, alerts and environmental noises may sound different when
wearing the product.
Be aware of how these signals differ in terms of their sound so that you are
able to recognize the signals in corresponding situations.
Do not use the product when driving motor vehicles, cycling, when operating
machines or in other situations where impaired awareness of noises in your
surroundings could pose a risk to you or others. At the same time, also
observe the legal regulations and provisions in the country where you use the
product.
Lay the cable so that it does not pose a tripping hazard. Keep the cable away
from sharp edges and hot areas, and avoid it from clamping or crushing. To
prevent malfunction or damage to the product, avoid accidental falls, do not
crush, puncture or exercise a high level of pressure on the product. Keep the
product away from humidity, water or other liquids.
Do not store or expose your product to any source of heat, direct sunlight,
radiators, stoves or other heat sources such as the dashboard of your car in
the summer.
Do not try to modify, repair or disassemble the product.
Do not use a damaged product.
Do not under any circumstances use aggressive cleaning agents, alcohol or
other chemical solutions for cleaning as they can damage the housing or even
impair the functionality of the product.
Do not immerse the product in water or other liquids.
Were are no serviceable parts inside the product. Never open/disassemble it.
Keep the product out of reach of children.
Never allow children or persons with disabilities to use electrical products
without supervision.
Make sure that children do not play with the plastic wrapping.
Wey may swallow it when playing and suffocate.
Make sure children do not remove any small parts from the product and play
with them.
USE Charging
For first time use, charge the battery until it is full. To charge, open the headset’s USB jack and plug the charging cable into the charging port. Red light means it is charging, blue light means the battery has been fully charged.
Turn on
Press and hold the Multifunction button of the headset for about 3 seconds, then the blue light will flash.
Pairing
Place the headset and the pairing device within 1 meter. Press and hold the Multifunction button for 6-8 seconds until the red and blue light flashes alternately, signaling that it is in pairing mode. Activate your pairing Bluetooth® feature. Search for “PCBHSTEREO”, and select it to connect. If a password is requested, key in “0000”.
Automatic reconnection
Once the headset and the pairing device have been paired together, they will automatically be reconnected if they are within distance of each other and the pairing device’s Bluetooth function is turned on.
Answer a call
Press the Multifunction button to take a call.
Reject a call
Press and hold the Multifunction button to reject a call.
Redialing
Double click the Multifunction button to redial a latest number in your call logs.
Change track
Press the + or – button to switch the next or previous track.
Adjusting the volume
Press and hold the + or – button to adjust the volume.
Turning off Headset
In ON MODE, press and hold MFB for 3 seconds, the indicator light flashes red for 3 times and the headset prompts are sounds, then the headset will enter into OFF MODE.
Auto Power off
- Under the connection of phones, if you disconnect the earphone, the earphone will auto power off after 10 minutes.
- If you don’t connect phone when blue and red light flashing , the earphone will auto power off in 5 minutes.
Multi-point function
- Connect the Bluetooth headset with smartphone “A”, and then deactivate the Bluetooth function of the smartphone “A”.
- Connect the Bluetooth headset with smartphone “B”.
- Activate the Bluetooth function of the smartphone “A” again, then the headset will auto connect to the smartphone “A”. Now the Bluetooth headset is connected to smartphone “A” and “B”.
Restore factory settings
In power-off status, hold the multifunction button for 10 seconds until the red and blue indicators turn off to restore the factory settings.
Cleaning
If necessary, clean the earphones with a damp cloth and let it dry completely
before use.
Do not use any solvents, corrosive or gaseous cleaning agents.
Make sure no water or other liquids penetrate the housing.
CUSTOMER’S INFORMATION FOR RIGHT WASTE OF THIS PRODUCT (2013/56/EU
Directive)
This marking on the product or its packaging means that the product at the end of its life, including the unremovable battery, must be separated from other types of waste to recycle it responsibly. Safety’s use of this product is guaranteed from the respect of this instructions manual, keep it and carefully use it for all life of the product. The product doesn’t need any kind of technical maintenance, NEVER DISASSEMBLE IT. The battery inside the product is integrated and not replaceable. Don not try to remove li-ion/polymer battery included in inside the product because can produce overhead’s danger, burning and injury. The battery must be removed only by qualified professional technicians, that are able to remove it without any kind of danger and to recycle it in the respect of the law. Users should give free end of life product into the local separate collection centers or to the retailer, in reason of one to one, or free if the product size is bigger than 25 cm. Adequate waste disposal permit to award the product to recycling, treatment with ecofriendly compatible disposal conduce to prevent possible harm to the environment or human health and promote the reuse and/or product materials recycling. Unauthorized waste disposal of electronic product, cell and battery from household user involve currency legislation sanctions.
Technical specifications
- Specification Bluetooth® Version: Bluetooth® 4.2
- Standby time: 90h
- Talk time: 4h
- Music time: 3h
- Earphone charging time: 2 hours Battery: 3.7 V/55 mAh (0.204 Wh) polymer lithium battery
- Wireless distance: 10 m
- Software and version: V1.3 Frequency response: 2.402 ~ 2.480 GHz Max power: 0,82 mW (-0,86 dBm) Speaker diameter: 10mm
This product complies with RoHS 2011/65/EU. The product carries the CE mark
and complies with safety standards established by the European Union. Hereby,
Celly SpA declares that the wireless earphones PCBHSTEREO is in compliance
with Directive 2014/53/EU. The full text of the EU declaration of conformity
is available at the following internet address:
www.celly.com/exchange/CELLY-
SPA/Dichiarazioni_di_conformita/PCBHSTEREO/DOC_PCBHSTEREO.pdf
Celly® is a trademark owned by CELLY S.p.A.
All brands are registered trademarks of their respective owners.
Imported by CELLY S.p.A., via Energy Park 22,
20871 Vimercate (MB) – Italy
Made in China.