AVANTCO 177EMBS65SS Meat Saw Countertop Stainless Steel Instructions
- June 1, 2024
- AVANTCO
Table of Contents
Cleaning Instructions
02/2024
Meat Saw
#177EMBS65SS
CAUTION:
This unit has a sharp blade. We are not responsible for any injuries resulting
from improper operation of this machine. Take care while assembling and
operating to avoid injury. Use caution when cleaning the saw blade.
General Cleaning
1. Clean and remove excess product from scraper.
2. Wipe down all touched surfaces.
3. Remove all excess product buildup.
Daily Cleaning & Maintenance
1. Before beginning to clean, turn off the unit and unplug from the
electrical outlet. Make sure the unit is cooled completely.
2. Wear cut-resistant gloves during cleaning for safety.
3. Remove any excess food material and discard.
4. Inspect the unit and blade to ensure there is not any breakage or
corrosion.
5. Wipe down all surfaces with hot, soapy water. Let the unit air dry
completely before next use.
6. Remove any excess product from the scraper.
7. Remove the scraper by loosening the scraper protection knob. Then,
pull the scraper blades toward you to remove them from the machine.
How To Clean Avantco Meat and Bone Saw Parts
1. Use a standard, three-compartment sink cleaning method.
2. Wash the parts in hot, soapy water with a long bristle brush.
3. Rinse all parts with hot water.
4. Sanitize all parts with Noble Sanitation Cleaner (Noble Chemical
QuikSan Sanitizer).
Monthly Cleaning
1. Before beginning to clean, turn off the unit and unplug from the
electrical outlet. Make sure the unit is cooled completely.
2. Wear cut-resistant gloves during cleaning for safety.
3. Inspect the unit to ensure there is not any breakage or corrosion on
any parts.
4. For best performance, clean the blades with hot, soapy water and towel
dry. Once dry, apply a coat of food-grade oil on the blades to prevent
rusting.
Blade Replacement
- Some maintenance can be done on an as-needed basis.
- Before performing any maintenance or cleaning, turn off the unit and unplug from the electrical outlet. Give time for the machine to cool completely before inspecting the unit and blade for breakage or corrosion.
1. Open the upper and lower cavity doors.
2. Loosen the tension knob at the top to take the blade off the wheels.
3. Loosen the scraper protection knob just enough to take the scraper off the machine.
4. Clean the blade and scraper with hot water and a brush. Note:
Follow the instructions on How to Clean Avantco Meat and Bone Saw Parts on
page 1.
5. Once dry, replace the scraper and tighten it in place by adjusting the
scraper protection knob.
6. Place the new blade over both wheels, facing forward with the teeth
flush with the edge of the wheel.
7. Secure the blade in place by tightening the tension knob.
8. Close both the upper and lower cavity doors.
Documents / Resources
|
AVANTCO 177EMBS65SS Meat Saw Countertop Stainless
Steel
[pdf] Instructions
177EMBS65SS Meat Saw Countertop Stainless Steel, 177EMBS65SS, Meat Saw
Countertop Stainless Steel, Countertop Stainless Steel, Stainless Steel, Steel
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>