Danby DPSL120B1W Through-The-Wall Air Conditioner Sleeve Owner’s Manual

June 12, 2024
Danby

Danby logo Do the right thing
INSTALLATION INSTRUCTIONS

INCLUDED PARTS – SLEEVE

  1. Bottom panel
  2. Top, left and right panel assembly
  3. Rear grill
  4. Seal A (26.4” long)
  5. Seal B (1.6” long) x2
  6. Insulation strips x2
  7.  Long screws x4
  8. Short screws x14

Danby DPSL120B1W Through The Wall Air Conditioner Sleeve
SLEEVE

INCLUDED PARTS – DRAIN KIT

  1.  Cover plate x1
  2. Cover plate with drain outlet
  3. Foam gasket x2
  4. Bent tube x1
  5. Screws ST3.9*14 (optional) x4/x6

Note: The drain kit is optional. If you plan to use the  drain kit, make sure to assemble and install it beforeinstalling the air conditioner in the sleeve.Danby DPSL120B1W Through The Wall Air Conditioner Sleeve
drain

ASSEMBLY – SLEEVE

  1.  Open the left and right panels.
  2. Secure with 6 short screws.
  3. Use 8 short screws to secure the bottom panel.
  4. Attach foam seal A and B.
  5. Attach foam strips to the rear grill in the positions shown.
  6. Attach the rear grille to the sleeve by sliding the holes in the rear grille over the protruding screws on the sleeve as shown.
  7. Once the holes in the rear grille clear the head of the screws in the sleeve, pull down on the rear grille so that the screws slide into the “U” holes as shown.
  8. The rear grille is properly installed when the screws in the sleeve slide into the bottom of the “U” holes on the rear grille.
  9. Add two additional screws through the rear grille into the sleeve as shown below.

Danby DPSL120B1W Through The Wall Air Conditioner Sleeve
additional

ASSEMBLY – DRAIN KIT

Attach the foam gaskets to the cover plates and insert the bent hose into the cover plates that has a hole in it.
Install the cover plate with the tube on the outlet at the back of the sleeve. It can be placed on either the left or right side. Make sure the tube’s position will allow the sleeve to fi t in the wall and that the drain is positioned so that water will drain outside of the
house and not into the interior of the wall. Danby DPSL120B1W Through The
Wall Air Conditioner Sleeve ASSEMBLY

LIMITED “IN HOME” WARRANTY

This quality product is warranted to be free from manufacturer’s defects in material and workmanship, provided that the unit is used under the normal operating conditions intended by the manufacturer. This warranty is available only to the person to whom the unit was originally sold by Danby Products Limited (Canada) or Danby Products Inc. (U.S.A.) (hereafter “Danby”) or by an authorized distributor of Danby, and is non-transferable.

TERMS OF WARRANTY

Plastic parts are warranted for thirty (30) days from the date of purchase, with no extensions provided.
First 2 years: During the fi rst two (2) years, any functional parts of this product found to be defective, will be repaired or replaced, at warranter’s option, at no charge to the original purchaser.
To obtain service: Contact the dealer where the unit was purchased, or contact the nearest authorized Danby service depot, where service must be performed by a qualifi ed service technician. If service is performed on the unit by anyone other than an authorized service depot, all obligations of Danby under this warranty shall be void.
Boundaries of In Home service: Danby reserves the right to limit the boundaries of “In Home Service” to the proximity of an authorized service depot. Any appliance requiring service outside the limited boundaries of “In Home Service”, will be the consumer’s responsibility to transport at their own expense to the original point of purchase or a service depot for repair. If the appliance is installed in a location that is 100 kilometers (62 miles) or more from the nearest service center, it must be delivered to the nearest
authorized Danby Service Depot by the purchaser. Transportation charges to and from the service location are not protected by this warranty and are the responsibility of the purchaser.
Nothing within this warranty shall imply that Danby will be responsible or liable for any spoilage or damage to food or other contents of this appliance, whether due to any defect of the appliance, or its use, whether proper or improper.

EXCLUSIONS

Save as herein provided, by Danby, there are no other warranties, conditions, representations or guarantees, express or implied, made or intended byDanby or its authorized distributors and all other warranties, conditions, representations or guarantees, including any warranties, conditions, representations or guarantees under any Sale of Goods Act or like legislation or statute is hereby expressly excluded. Save as herein provided, Danby shall not be responsible for any damages to persons or property, including the unit itself, howsoever caused or any consequential damages arising from the malfunction of the unit and by the purchase of the unit, the purchaser does hereby agree to indemnify and hold harmless Danby from any claim for damages to persons or property caused by the unit.

GENERAL PROVISIONS

No warranty or insurance herein contained or set out shall apply when
damage or repair is caused by any of the following:

  1. Power failure.
  2. Damage in transit or when moving the appliance.
  3. Improper power supply such as low voltage, defective house wiring or inadequate fuses.
  4. Accident, alteration, abuse or misuse of the appliance such as inadequate air circulation in the room or abnormal operating conditions (i.e.. extremely high or low room temperature).
  5. Use for commercial or industrial purposes (i.e.. If the appliance is not installed in a domestic residence).
  6. Fire, water damage, theft, war, riot, hostility, acts of God such as hurricanes, fl oods etc.
  7. Service calls resulting in customer education.
  8.  Improper Installation (ie. Building-in of a free standing appliance or using an appliance outdoors that is not approved for outdoor application, including but not limited to: garages, patios, porches or anywhere that is not properly insulated or climate controlled).

Proof of purchase date will be required for warranty claims; retain bills of sale. In the event that warranty service is required, present the proof of purchase to our authorized service depot.

NOTES…………………………………………………………………………………………………………………

Danby logo Danby Products Limited, Guelph, Ontario, Canada N1H 6Z9
Danby Products Inc. Findlay, Ohio, U.S.A. 45840
www.Danby.com

2023.01.17
*Trademark of Danby Products
Printed in China

Documents / Resources

| Danby DPSL120B1W Through-The-Wall Air Conditioner Sleeve [pdf] Owner's Manual
DPSL120B1W Through-The-Wall Air Conditioner Sleeve, DPSL120B1W, Through-The- Wall Air Conditioner Sleeve, Air Conditioner Sleeve, Conditioner Sleeve, Sleeve
---|---

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals