DIGI InfoTag3.7 ESL Electronic Price List System Instruction Manual

InfoTag3.7 ESL Electronic Price List System
Instruction Manual SERVICE MANUAL
InfoTag3.7

Notice
DIGI®
The material contained in this document is proprietary and for information only and is subject to change without notice. DIGI Singapore Pte. Ltd. assumes no responsibility for any errors or damages arising from misinterpretation of any procedure.
Screen displays, operating procedures and supporting features might vary with different software version releases.
This document shall not be reproduced whether in part or whole without the written consent from DIGI Singapore Pte. Ltd.

Safety Information

The operator of the equipment shall comply with the safety and warning indications and procedures outlined in this document. DIGI Singapore Pte. Ltd. assumes no responsibility or liability for failure to comply with these requirements.

• Repair and servicing of product, shall only be carried out by trained and qualified personnel.

Disclaimer:
Specifications are subject to change without notice. All dimensions shown are approximate. Please be aware that DIGI has indicated that its hardware and software used in the product may require additional updates in the future as our  product is continually under development. The need for such updates most likely applies to the Printer software.

CAUTIONS:
FOR PLUGGABLE EQUIPMENT, THAT THE SOCKET-OUTLET SHALL BE INSTALLED NEAR THE
EQUIPMENT AND SHALL BE EASILY ACCESSIBLE.
FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH SAME TYPE AND RATING OF FUSE.
DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE RECOMMENDED BY THE MANUFACTURER. DISCARD USED BATTERIES ACCORDING TO THE MANUFACTURER’S INSTRUCTIONS

Safety Regulations

Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential  installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no  guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
IDA Compliance Statement: (Singapore)
This equipment registered to comply with IDA (Info-Communications Development Authority of Singapore) Standard under Dealer’s Class License.

Industry Canada statement:
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:
Radiation Exposure Statement:
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment should be installed and operated so that the radiator is kept at least 7.9 inches (20 cm) or more away from a person’s body (excluding extremities: hands, wrists, feet and ankles).

General

1.1 Model Specification
Model: InfoTag3.7
Dimensions (in mm) :  Product size – 104.4(L) X 58.2(H) X 16.2(W)
LCD Size – 93mm (H) x 53mm (V)
LCD Resolution – 416 x 240 dots (Dpi:130)
Weight : 45g approx.
Power Source : DC Cell Button Battery 3.0V x 3
Operating Temperature : 5 °C to + 40 °C
Humidity : 65% Max. Non-condensing
Housing material : ABS plastic casing, PC battery cover
Battery Specification : Type – CR2450 (Cell Button Battery)
Nominal Voltage – 3.0V
Life Time – 5 years (2 update/day)
Weight – 6.6g approx.
1.2 Operating Specification

*Note: The RF Range maybe varies in different environment.
Certification| : CE, RCM, TELEC

InfoTag3.7Diagram

2.1 Overall Layout and Label design

Nameplate
Product shows approval content by default. To retrieve this content, simple power on/off the device.
2.2 Replacement of Info Tag Battery

i. Pull off the battery cover from back of the Info Tag.
ii. Replace the new battery. (Ensure the Battery polarity is correct)
Caution : Dispose of the Battery according the Safety Guideline.
i. Avoid placing the battery in reverse polarity.
ii. Do not heat or dispose of fire. May burst or release toxic material.
iii. Do not charge.
iv. Do not short circuit.
v. Do not solder the battery directly.
vi. Do not ingest battery, Chemical Burn Hazard
vii. Keep new and used batteries away from children
viii. If the battery compartment does not close securely, stop using the product and keep it away from children
ix. Do not solder the battery directly.
2.3 Button Cell Specifications

Warning
This equipment is professional equipment and is not suitable for use in locations where children are likely to be present. This equipment is sold through special sales channels only, and is not sold to the general public.
2.4 ESL Attachment (Refer to ESL Attachment Catalogue)
For all information about the ESL Various Attachment type, function, installation etc. Please refer to ESL Attachment Catalogue
http://www.digiesl.com.tw/digiesl/sys4.asp
http://www.teraoka.com.tw/digi/article.aspx?id=77
http://www.digiesl.com/

2.5 Product Handling of Info Tag
Handle product with care. Do not expose product to corrosive chemical solution, any organic solvent acidic or alkaline. If cleaning is required, wash only water or mild soap solution.
Do not attempt to disassemble, apply force or heavy load to the product.
No user serviceable parts inside except battery

Revision Records

Serial No.| Date| Edition Status| Description of Changes| Software Version| Remarks
---|---|---|---|---|---
1| 2/5/2023| 0| First Release| F001|
2| 9/6/2023| 1| Update IC statement| F010|
| | | | |
| | | | |
| | | | |
| | | | |
| | | | |
| | | | |
| | | | |
| | | | |

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>