rogerseller 3606004051XX Hob Mixer and Outlet Instruction Manual
- June 12, 2024
- rogerseller
Table of Contents
rogerseller 3606004051XX Hob Mixer and Outlet
Eccentric by Rogerseller Hob Mounted Mixer & Outlet
Installation of mixer:
- Bench hole diameter must be a minimum of 37mm for installation of Mixer
- Maximum bench thickness 38mm for Mixer
- Firmly tighten the flexible hoses into the base of the body. If the hoses have red and blue indicators make sure they are connected to the correct inlet hole in the mixer base. The hot inlet hole is the closest hole to the H stamp.
- Feed the hoses through the basin hole, one at a time.
- Under the Basin / Bench) Place the back nut over the end of the hoses.
- Lock the mixer onto the basin by tightening back nut onto the body.
- Connect the flexible hoses to the supply lines, making sure the hot water is connected to the hot water hose. Rogerseller recommends the installation of stop taps and in-line filters to ensure a cleaner flow of water to the mixer.
- Prior to introducing the mains water supply, open the handle in the mixed position, midway between full hot and cold. Then introduce the mains water to flush the supply lines.
- Install Outlet, connect to mixer & test.
Dimension
Specifications
It is a requirement of state plumbing codes that licensed plumbers carry out all tapware installations. All installations must comply with the relevant requirements of AS/NZS3500 and local plumbing codes.
Pressure
Maximum Hydrostatic Pressure – 1000kpa
Recommended Maximum Hydrostatic Pressure – 500 kpa. (AS/NZS 3500)
Recommended Minimum Hydrostatic Pressure – 150 kpa.
Maximum Hydrostatic Pressure may be exceeded under test conditions only in
accordance with AS/NZS 3500. Where hydrostatic pressure exceeds the maximum
stated above, pressure limiting valves must be installed or warranty will be
void.
Temperature
Maximum Water Temperature – 80°C
For optimum performance, Hot and Cold inlet water pressure should be equal.
Sink / Basin Requirement
Hole size : Ø40 – 42mm
Maximum Bench Thickness – 40mm
Care and Maintenance
- Product should be inspected for surface damage prior to installation.
- Cleaning and handling of all finishes must be performed carefully.
- Clean products using a soft cloth with warm soapy water only.
- Never use harsh detergents or abrasive cleaners as these will damage the product.
- Water marks can be removed from Matt Finishes with an application of a carnauba wax based non-abrasive polish on a micro fibre cloth.
- Do not use undue pressure when cleaning and wipe in one direction only.
- Contact with harsh chemicals such as hair dye, hair bleach etc will result in damage to the finish.
- Tapware should never be installed using acetone silicones.
- Avoid the use of wax based furniture creams as this can result in a build up of deposits which will detract from the appearance.
- Damage to finishes arising from improper installation or post installation use or failure to observe the above care and cleaning instructions will void all warranty agreements.
Dimensions are approximate. Information in this installation instruction is representative of the product available at the time of printing. Due to our policy of continuous product development, the design and specifications depicted are subject to change without notice. Please confirm all particulars with your client advisor prior to purchase.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>