rogerseller 3506003201 Tonic Matt Black Tonic Up Wall Mixer Installation Guide
- June 9, 2024
- rogerseller
Table of Contents
3506003201 Tonic Matt Black Tonic Up Wall Mixer
Installation Guide
3506003201 Tonic Matt Black Tonic Up Wall Mixer
Specification
Tonic by Rogerseller
Shower on Integrated Union
3506003201 — Chrome
Other finishes available
Parts List
- Hand Shower
- Flow Controller
- Conical Nut (with O-ring)
- Shower Hose
- Rubber Sealing Washer
- Saddle
Installation
Step 1
With approx. 10-15mm of wall outlet protruding the finished wall, place the
wall plate over the wall outlet.
Step 2
Apply a sufficient amount of thread tape or sealant to the wall outlet, then
in a clockwise direction, fix the swivel bracket to the wall outlet until it
reaches the wall plate and is in the correct orientation as illustrated.
Step 3
Take the Shower hose and connect the hose end with the conical nut and o-ring
onto the hand shower ensuring the flow controller is positioned inside the
conical nut.
Hook the hand shower into the saddle.
Connect the opposing end to the threaded connection located on the underside
of the swivel bracket ensuring the rubber sealing washer is in position.
Check for water tightness and remedy as required.
Specifications
It is a requirement of state plumbing codes that licensed plumbers carry out
all tapware installations.
All installations must comply with the relevant requirements of AS/NZS3500 and
local plumbing codes.
Where showers incorporate flow controllers, instructions that care be
exercised during installation to ensure that the male connecting threads do
not damage the flow controllers.
A backflow prevention / dual check device must be installed to the bottom of
the rail between the rail end and the hose if the hand shower can reach the
shower floor when installed.
Pressure
Maximum Hydrostatic Pressure – 1000kpa
Recommended Maximum Hydrostatic Pressure – 500 kpa. (AS/NZS 3500)
Recommended Minimum Hydrostatic Pressure – 150 kpa.
Maximum Hydrostatic Pressure may be exceeded under test conditions only in
accordance with AS/NZS 3500. Where hydrostatic pressure exceeds the maximum
stated above, pressure limiting valves must be installed or warranty will be
void.
Temperature
Maximum Water Temperature – 80°C
For optimum performance, Hot and Cold inlet water pressure should be equal.
Care and Maintenance
[1] Product should be inspected for surface damage prior to installation. [2] Cleaning and handling of all finishes must be performed carefully. [3] Clean products using a soft cloth with warm soapy water only. [4] Never use harsh detergents or abrasive cleaners as these will damage the product. [5] Water marks can be removed from Matt Finishes with an application of a carnauba wax based non-abrasive polish on a microfibre cloth. [6] Do not use undue pressure when cleaning and wipe in one direction only. [7] Contact with harsh chemicals such as hair dye, hair bleach etc will result in damage to the finish. [8] Tapware should never be installed using acetone silicones. [9] Avoid the use of wax based furniture creams as this can result in a build up of deposits which will detract from the appearance. [10] Damage to finishes arising from improper installation or post installation use or failure to observe the above care and cleaning instructions will void all warranty agreements.
Warranty
Rogerseller tapware, bathroom fittings and sanitaryware are covered by a five
(5) year warranty from date of purchase. For full terms and conditions please
refer to rogerseller.com.au
Dimensions are approximate. Information in this installation instruction is
representative of the product available at the time of printing. Due to our
policy of continuous product development, the design and specifications
depicted are subject to change without notice. Please confirm all particulars
with your client advisor prior to purchase.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>