Intellitronix M9107 LED Temperature Gauge Installation Guide
- June 12, 2024
- Intellitronix
Table of Contents
**Intellitronix M9107 LED Temperature Gauge Installation Guide
**
Always disconnect the battery before attempting any electrical work on your vehicle.
KIT COMPONENTS
- One (1) LED Gauge
- One (1) S8013 temperature sender
WIRING INSTRUCTIONS
Note: Automotive circuit connectors are the preferred method of connecting wires. However, you may solder if you prefer.
Ground – Black Connect directly to an engine ground such as the engine block. For the most accurate readings, connect to the same ground as the sending unit.
Power – Red Connect to a switched +12V source such as the ignition switch.
Dimmer – Purple Connect to the parking lights to dim the LEDs 50% when the headlights are on. However, do not connect to the headlight rheostat control wire; the dimming feature will not work properly. Otherwise, connect to ground for permanent 100% brightness.
Temperature – Blue Connect to the output of the temperature sending unit.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>