SCHONBEK BWSW14318 Beyond Vail LED Outdoor Wall Light Instruction Manual

: June 12, 2024
: SCHONBEK

Table of Contents

PREPARATION
Wall Plate Dimensions
HARDWARE
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SCHONBEK BWSW14318 Beyond Vail LED Outdoor Wall Light Instruction Manual

SCHONBEK BWSW14318 Beyond Vail LED Outdoor Wall Light Instruction
Manual

WARNING

IMPORTANT: NEVER attempt any work without shutting off the electricity.

Read all instructions before installing.
System is intended for installation in accordance with the National Electrical Code (NEC), other applicable installation code(s) and local regulations by a licensed electrician familiar with the operation of the product and the hazards involved.
Go to the main fuse box, or circuit breaker panel. Place the main power switch in the “OFFK position and unscrew the fuse (s) or switch “OFFK the circuit breaker switch (es) that control the power to the fixture (s) or room that you are working on.
Place the wall switch in the “OFF” position.
FAILURE TO INSTALL THIS FIXTURE IN ACCORDANCE WITH THESE INSTRUCTIONS MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND/OR PROPERTY DAMAGE.
CAUTION
All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are worn out or broken. Failure to follow this instruction could invalidate the ETUCETL Listing of this fixture.
When handling the fixture, do not apply pressure to the LEDs or bulbs. Hold the fixture by the base only.
Do not exceed maximum wattage noted on the fixture. Use only the recommended LED or standard lamps with the fixture.

PREPARATION

Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.
Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig .1)
Remove the mounting screw (B) and rubber gasket (C) from the fixture.
The lamp can switch between three color temperatures (3000K-3500K-4000K), which can be adjusted to your preference with the switch in the fixture (Fig.4).
Drill holes in the wall aligned with the key holes located on the wall plate, insert the plastic anchor(D).
Secure wall plate to the junction box using standard junction box screws that comes with the junction box, fasten it to the wall using anchor Screw (E). (i) It is recommended to use only original junction box screws or replacements provided by junction box manufacturer. (ii) The side of the mounting plate marked “GND” must face out.
CONNECTING THE WIRES (Fig 2)
Connect the driver’ s input wires to the junction box wires as shown in Fig. 2 using wire connectors (A) provided. Ensure wire connectors are secure. Connect the fixture’s ground wire to the ground in the junction box; this will be either a green wire or a bare copper wire. After fixture is wired to house wires, tuck wires carefully inside the junction box.
Place the fixture over the mounting back plate and secure it with mounting screws (B) and the rubber gasket (C).
COMPLETING THE INSTALLATION
To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the outside of fixture back plate where it meets the wall. Leave a space at the bottom to allow moisture to escape(Fig.4)
Coastal conditions may cause mineral and residue build-up on the fixture. We recommend that customers in coastal areas clean all external surfaces of the fixture once every two weeks with a wet cloth.