SCHONBEK BWS10218 Echelon 18 Inch LED Wall Sconce Instruction Manual

Table of Contents

Fixture
BWS10218 / B WS10224

To Install Fixture Fig. 1

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION

PREPARATION

Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.

MOUNTING THE FIXTURE (Fig. 1)

Remove the mounting screw (B) from the mounting back plate.
The lamp can switch between three color temperatures (3000K-3500K-4000K), which can be adjusted to your preference with the switch in the canopy (Fig.3).
Drill holes in the wall aligned with the key holes located in the mounting plate. Insert the plastic anchors (D).
Secure the mounting plate to the junction box using the screws provided with the junction box. Fasten the back plate to the wall with the plastic anchors using the wood screws (E) provided.
Note: (i)using any other non-original-manufacturer provided junction box screw may result in safety issue; (ii) The side of the mounting plate marked “GND” must face out.

CONNECTING THE WIRES (Fig. 2)

Properly secure the safety cord to the bracket on the mounting back plate to temporarily hang the xture in place and aid installation.
Connect the input wires to junction box as shown in Fig .2. Making sure that all wire connectors (A) are secured. If your outlet box has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the back plate using the GND screw provided. After wires are connected, tuck them carefully inside the junction box.

COMPLETING THE INSTALLATION

Secure the xture by mounting the backplate to the mounting back plate. Secure the xture to the mounting back plate using the mounting screw (B).
Put the crystal sitting on the the xture. Secure the xed plate and crystal to the lamp body using the screw (C), then place the cover on the xing plate to attract the magnet.

Fig. 2 Wiring

Fig. 3 Switch

WARNING

IMPORTANT: NEVER attempt any work without shutting off the electricity.

Read all instructions before installing.
System is intended for installation in accordance with the National Electrical Code (NEC), other applicable installation code(s) and local regulations by a licensed electrician familiar with the operation of the product and the hazards involved.
Go to the main fuse box, or circuit breaker panel. Place the main power switch in the “OFF” position and unscrew the fuse (s) or switch ”OFF” the circuit breaker switch (es) that control the power to the fixture (s) or room that you are working on.
Place the wall switch in the “OFF” position.
FAILURE TO INSTALL THIS FIXTURE IN ACCORDANCE WITH THESE INSTRUCTIONS MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND/OR PROPERTY DAMAGE.

CAUTION

All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are worn out or broken. Failure to follow this instruction could invalidate the ETL/CETL Listing of this fixture.
When handling the fixture, do not apply pressure to the LEDs or bulbs. Hold the fixture by the base only.
Do not exceed maximum wattage noted on the fixture. Use only the recommended LED or standard lamps with the fixture.

Schonbek,
61 Industrial Blvd,
Plattsburg,
New York,
12901
Phone: 1-800-836-1892
Fax: 518-563-4228
www.schonbek.com
JAN 2021