ZOLL X Series Advanced Monitor Defibrillator Instructions

June 4, 2024
ZOLL

X Series Advanced Monitor Defibrillator
Instructions

Process for Cleaning the ZOLL X Series Advanced

  • Use only the recommended cleaning agents listed below to clean the device.
    Follow the directions on the product label for use and storage.

  • DO NOT allow cleaning agents or water to run into the crevices or connector openings at any time.

  • Always check monitor and connector opening for unusual wear, damage, or dampness while cleaning.

  • Cleaning NIBP Cuffs — Clean the cuffs with common hospital disinfectants, including Clorox ® (1:10 solution), Isopropyl alcohol, Lysol ® solution, Phisohex ®, Quatricide ®, Virex ® and Vesphene ®

  • Wash gently with the solution, then rinse. DO NOT allow the solution to enter cuff tubes. Allow the cuff and hose to completely dry before patient use.

  • Reusable SpO2 Sensors — Disconnect the sensor from the patient cable, if appropriate.
    Wipe the entire sensor clean with a 70% isopropyl alcohol moistened pad. Allow the sensor to dry before returning it to use. Caution: Do not submerge the pulse-oximeter in any cleaning solution or attempt to sterilize by autoclave, irradiation, steam, gas, ethylene oxide or any other method. This will seriously damage the pulse co-oximeter.

  • Cleaning Cables and Accessories (including carrying case) — Cables, cuff tubing, paddles, and other accessories can be wiped clean with the recommended cleaning agents listed below.

  • Cleaning the Print Head — To clean the recorder print head, perform the following steps:
    1. Pull the printer door open, and remove any paper.
    2. Locate the print head along the front floor of the printer compartment.
    3. Gently wipe the print head with a cotton swab moistened with Isopropyl alcohol,
    and dry residual alcohol with another dry cotton swab.
    4. Place the paper back into the unit and close the cover.

  • Refer to the Operator’s Guide for full cleaning and operating instructions.

Products for Cleaning the ZOLL X Series Advanced

  • Sodium Hypochlorite (Bleach) Solution or Wipes (up to 10,000 ppm)
  • 70% Isopropyl Alcohol (IPA) Wipes
  • Clinell ® Universal Wipes
  • Ethanol Disinfectionwith detergent
  • Super Sani-Cloth ® Wipes
  • Sani-Cloth Plus ® Wipes
  • Oxivir ® TB Wipes
  • CaviWipes ® XL Wipes
  • Clorox Healthcare Hydrogen Peroxide Wipes
  • Hydrogen Peroxide Solution
  • Wex-Cide ® 128 Solution
  • Coverage Spray HB Plus
  • Bleach Germicidal Wipes
  • Warm Water and Soap

REV A 0420

Documents / Resources

| ZOLL X Series Advanced Monitor Defibrillator [pdf] Instructions
X Series, Advanced Monitor Defibrillator, X Series Advanced Monitor Defibrillator, Monitor Defibrillator, Monitor, Defibrillator
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals