VIVALDI KEOPE.HP60 Top Speakers Instruction Manual
- June 12, 2024
- VIVALDI
Table of Contents
VIVALDI KEOPE.HP60 Top Speakers Instruction Manual
Model
KEOPE.HP60
PACKAGE CONTENTS
INTRODUCTION
Thank you for purchasing a Keope Line speaker. Please read and have a thorough understanding of the entire manual before installation and use. Keep the manual for maintenance.
COLOUR SHEATHS
HP60 Keope speaker can be customized by replacing the black Sheaths supplied with a model of your choice from the following 9 colors.
white KHP60W- grey KHP60G
- anthracite KHP60A
- sand KHP60S
- rust KHP60R
- cherry red KHP60C
- wisteria KHP60V
- cerulean blue KHP60B
- green KHP60E
IMPORTANT
In the constant effort to improve its products, Vivaldi srl reserves the right to bring modifications to the products without advance notice. In case of doubts, please consult a qualified professional or directly contact Vivaldi to the number +39 0421 307825.
Speakers and all theirs parts and accessories shall be used only for the purpose they were manufactured.
Vivaldi srl, is not liable for any direct or indirect damage to things and/or people, arising from a misuse / improper use / use other than the one is designed and manufactured for.
Some parts of this product are small, so pay attention and keep out of reach of children.
WARNING
- Always make sure that the structure on which you install the speaker is reliable and that the speaker is firmly fixed. Do not place the speakers on mobile surfaces.
- Do not touch or hit the woofer and the tweeter. If these parts are damaged, the sound could distort.
- When you connect the speaker, ensure that the amplifier is off. Once connected, gradually increase the volume, verifying that the sound does not distort.
- Do not listen to sound at too high level when changing the input source, installing or removing cables. These operations must be done when you are sure that the amplifier is off.
- Don’t attempt to clean the speakers with chemical solvents as this may damage the surface. Wash the sheath by hand up to 40°C.
EXAMPLE OF 8Ω SYSTEM CONNECTION
Observe correct polarity for maximum bass performance and the Amplifiers impedance (8 Ohm).
ATTENTION
- Most speaker damages are caused by the clipping effect of amplifiers with too little power (wattage)
- An over driven amplifier clips the waveforms and sends distortion to the speakers.
- Clipping is usually audible; this effect may vary from a scratching sound to a distorted or unclear sound.
- If you hear this condition at high volume, turn it down until the distortion is no longer audible.
- The warranty does not cover damages caused by the speakers operating into distortion
SPECIFICATIONS
VIVALDI SRL by VIVALDI UNITED GROUP
Headquarter: Via Enrico Fermi, 8
Warehouse: Via Edison, 4
30020 Noventa di Piave (VE) – IT
phone: +39 0421 307825
info@vivaldigroup.it www.vivaldigroup.it
Vivaldi srl on going effort to improve its products, reserves the right to make technical and aesthetic changes effectively without obligation to notice.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>