LASER 3410 Gas Soldering Kit Instruction Manual
- June 12, 2024
- Laser
Table of Contents
Part No. 3410
Gas Soldering Kit 8pc
Instructions
Contents
Soldering Iron
Solder Tips x 2 (3.4 & 4.8mm)
Solder in plastic dispenser
Tip Adaptor
Needle Tip
Hot Knife Tip
Sponge
How to use your Gas Soldering Kit
Filling the Soldering Iron with Gas
Use filtered butane fuel.
Before filling make sure that the knob is pushed to the ‘OFF’ position (see
Fig 1).
Follow the directions on the butane fuel can. Applying the tip of the filler
valve to the base of the soldering iron. Using a pumping action, fill the
container (see Fig 2).
A complete fill takes about 10 seconds. Allow the gas to stabilise for a few
minutes, before lighting the torch.
Assembling
Screw the spring loaded tip adaptor to the soldering iron.
Lighting
Push the switch towards the ‘ON’ position, enough to hear a small ‘hissing’
sound (see Fig 3).
Push the spring loaded adaptor upwards to expose the burner head through the
chrome sleeve (circled in Fig 4) then light through the oval hole, release the
adaptor to cover the burner, the tip will then heat up.
Storage
Make sure that the torch is switched to its ‘OFF’ and cool, before storing or
leaving unattended.
Caution
- The burn tip and other accessory tips get hot in operation.
- Do not touch the tip or accessories, or place them on flammable objects.
- Always wear safety glasses when using the torch.
- Always have a fire extinguisher, or bucket of water near the torch work area.
- Under no circumstances should you attempt to repair a damaged torch.
- Never attempt to repair or heat a gasoline can, aerosol can or any compressed gas container.
- Use only in well ventilated areas.
- Avoid fumes from fluxes, lead based paint and all metal heating operations.
- Be especially careful to avoid fumes from cadmium plating and galvanised metal.
Warning: Keep out of reach of children
Safety First. Be Protected
Our products are designed to be used correctly and with care for the purpose
for which they are intended. No liability is accepted by the Tool Connection
for incorrect use of any of our products, and the Tool Connection cannot be
held responsible for any damage to personnel, property or equipment when using
the tools. Incorrect use will also invalidate the warranty.
If applicable, the applications database and any instructional information
provided has been designed to offer general guidance for a particular tool’s
use and while all attention is given to the accuracy of the data no project
should be attempted without referring first to the manufacturer’s technical
documentation (workshop or instruction manual) or the use of a recognised
authority such as Autodata.
It is our policy to continually improve our products and thus we reserve the
right to alter specifications and components without prior notice. It is the
responsibility of the user to ensure the suitability of the tools and
information prior to their use.
3410_Instructions_V3
www.lasertools.co.uk
Distributed by The Tool Connection Ltd
Kineton Road, Southam, Warwickshire CV47 0DR T +44 (0) 1926 815000 F +44 (0)
1926 81 5888 info@toolconnection.co.uk
www.toolconnection.co.uk
Guarantee
If this product fails through faulty materials or workmanship, contact our
service department direct on: +44 (0) 1926 818186. Normal wear and tear are
excluded as are consumable items and abuse.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>