saxby lighting 91796 Moda Bathroom Wall Light Fitting Instruction Manual
- June 12, 2024
- saxby lighting
Table of Contents
Moda Bathroom Wall Light Fitting (91796)
INSTRUCTION MANUAL
Safety Warnings
- It should be installed in accordance with local building regulations and is for domestic use only.
- Before installing your light fitting always switch off the mains supply and remove the appropriate fuse or switch off the appropriate circuit breaker before commencing installation.
- This is a Class 2 double insulated ****It does not require an Earth, and Live or Neutral must not be connected to Earth.
- This product contains delicate parts — be careful during handling and maintenance to avoid breakage.
- Included the 15W LED module (SMD), 6500K. This product contains a light source of energy efficiency class E. Non-replaceable light source Non-replaceable control gear
- This product is not suitable for dimming.
- This product is rated at may be installed in Zones 1 and 2 and Outside Zones of a bathroom where water jets are not used for cleaning purposes. If installing in a bathroom, a 30mA RCD must be used in accordance with IEE Wiring Regulations and the Building Regulations. An electrician must be consulted if in any doubt about your own competency or meaning of bathroom “Zones”, “Equipotential Bonding” or “RCD”.
- If you are in any doubt about your competence please consult a qualified electrician.
- If any modification is made it will invalidate the warranty and may render the product unsafe.
- This product is not suitable for use with a dimmer switch.
Care Information
Allow 10 minutes to cool before replacing, adjusting or cleaning.
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this
product.
Assembly/User Instructions
Before you start
Please read these instructions carefully before fitting and retain for
reference. Check the packaging and make sure that you have all the required
parts. Follow each assembly step in order to prevent incorrect assembly.
Ensure that the product is fully assembled as illustrated before use.
The assembly diagrams overleaf are intended as a guide – if in doubt consult a
qualified electrician.
The Light pack contains:
Light fitting.
Terminal connection block.
Fixing pack.
The following tools may be required:
Selection of cross and flat head screwdrivers.
Electric drill and assorted drill bits.
Wire strippers.
Electrical insulation tape.
UK Manufacturer: BH17 7BY
EU Manufacturer: Brilliant AG,
Brilliantstrasse 1, D-27442 Gnarrenburg
Assembly/User Instructions Continued
- Decide on the position of the light fitting / or remove existing light fitting. Take a note of the position of the electrical connections. Ensure there is a solid mounting surface.
- Using the wall back as a template, mark and drill the fixing holes. Take care not to damage any concealed wiring or pipes. The distance between the mounting holes is 580mm.
- Remove the end caps (A) and keep safe for refitting later.
- Remove the waterproof cover and set aside for refitting later (B).
- Connect the house wiring according to the Terminal Block diagram below. Pass the house wiring cable through the long grommet and connect to terminals. Ensure no strands of wire escape the Terminal Block (C).
- Refit waterproof cover set aside earlier (D).
- Fix the light in position using the supplied screws and wall plugs. (E)
- Refit end caps set aside earlier (F).
- Turn on the power and test. Switch on using rocker switch (G).
For further information, please visit https://www.lighting- info.co.uk/91796www.saxbylighting.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>