Whirlpool WRT104TFDB 28 Inch Top Freezer Refrigerator User Guide

Whirlpool WRT104TFDB 28 Inch Top Freezer Refrigerator

IMPORTANT: Unplug the refrigerator or disconnect the power. Provide additional support for the doors while the hinges are being moved. Do not depend on the door magnets to hold the doors in place while you are working. When removing the door, keep the screws and hinges. You will need them to reinstall the door. For more detailed door reversing instructions, see the User Instructions.

Remove Freezer and Refrigerator Doors

NOTE: After removing the doors, place them on a soft surface to avoid damaging the finish.

• While holding the door, remove 3 hex head screws and the hinge pin.
• Lift the freezer door from the center hinge pin.
• Center Hinge – Loosen the 2 screws (6 turns) on the left-hand side and remove the screw from the right-hand side.
• For models with base grilles, firmly pull the grille toward you to remove it.
• Center Hinge – While holding the door, loosen the 2 screws on the right-hand side and remove the screw from the left-hand side.
• Lift the refrigerator door from the bottom hinge.

NOTE: The hinge style will vary depending on the model.

Reverse Doors

Freezer Door

• Move the door stop, located at the bottom of the door, to the opposite side.
• Remove the handle and brand badge from the door.

NOTE: Handles are not factory-installed on some models.

• Place the badge (using the template provided on the last page of the manual), and the handle on the opposite sides of the door.
• Tighten the handle screws.

Reverse Doors

• Move the bottom hinge to the opposite side of the cabinet. Make sure the washer remains on the hinge pin.

NOTE: The hinge style will vary depending on the model.

• Set the Refrigerator door onto the bottom hinge pin.
• Tighten the screws (previously loosened), and reinstall and tighten the Center Hinge screw.

NOTE: Make sure washers are on both the top and bottom pins of the center hinge.

Install Doors

Freezer Door

• Move the 3 cabinet hole plugs to the opposite side.
• Insert the 3 Top Hinge screws so they are halfway into the Top Hinge and the top of the cabinet.
• Set the freezer door onto the Center Hinge.

Align Doors

• Align the Freezer and Refrigerator doors. NOTE: Make sure to allow a ¾” (19 mm) gap between the doors.
• Completely tighten the 4 Top Hinge screws.
• Move the base grille cover to the opposite side.
• Reinstall the base grille.
• Tighten the two screws (previously loosened), and reinstall and tighten the Center Hinge screw.

WARNING

Excessive Weight Hazard Use two or more people to move and install refrigerators. Failure to do so can result in a back or another injury.

OVERVIEW

Tools Required

W10661461B

• © 2014 Whirlpool Corporation.
• All rights reserved.

Documents / Resources

| Whirlpool WRT104TFDB 28 Inch Top Freezer Refrigerator [pdf] User Guide
WRT104TFDB 28 Inch Top Freezer Refrigerator, WRT104TFDB, 28 Inch Top Freezer Refrigerator, Freezer Refrigerator, Refrigerator
---|---

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>