SUSSEX CBS225 Calibre Bath Set Installation Guide
- June 12, 2024
- SUSSEX
Table of Contents
CBS225 Calibre Bath Set
Installation Guide
Rough in plumbing
-
Upon receiving, carefully unpack the Tapware;
NOTE: some parts have been combined for packaging purposes. -
Separate parts as shown in diagram. The Spindles are supplied with Hot and Cold indications.
-
Install the Spindles hand-tight until the seal of the Spindle makes contact with the seat.
-
To ensure a good seal is made; tighten the Spindle slightly more using an appropriate spanner.
Do not over-tighten.
NOTE: over-tightening the Spindles could damage the ceramic discs and in turn, void the manufacturer’s warranty. -
Place the Fibre washer over the seated Spindle and fit the Spindle Locknut. (Tighten well).
-
Seal the wall around the Spindle, position the Dress ring and secure using the Locking Flange.
-
Attach spindle adapter, ensure the identification mark is at the highest point when the spindle is in the off position.
-
Secure the spindle adapter using the locking screw. (Tighten Well).
-
Fit the handle body to the spindle, rotate handle until lever is in the vertical position (12 o’clock) and secure with the set screw. (Tighten Well).
NOTE: Set Screw must enter fixing groove. -
After completing the installation, establish water supply, check function of Tapware and ensure no water leaks.
Product code
| CBS175 | Bath set 175mm |
|---|---|
| CBS225 | Bath set 225mm |
Rough in (new wall breech)
- A standard Wall Breech (not supplied) is to be used in conjunction with this Tapware.
- Prepare a nogging to be fitted 32 – 35mm back from the front of the stud for the fixing of the Wall Breech (as shown).
- When fixing the Breech to the nogging; ensure the Tap seats of the Breech will be level and square to the Finished Wall.
- To ensure the Tapware will fit correctly the thickness of the finished wall coverings must be calculated prior to “Rough In”.
- When using thicker than normal wall covering, position the breech as forward as possible to ensure the Tapware will fit.
Using existing breech (changing tapware only)
- Remove the old Spindles and clean surrounding area.
- When installing new Spindles into old Breaching, it is highly recommended to use a re-seating tool to dress the Seat.
- Ensure the Spindle Seat is clean, flat and free of any debris.
- All lines must be completely flushed prior to fitting the Spindles.
- The distance from the finished Wall surface to the top of the Tap Seat must be between 2 to 12mm (See diagram)
- If the installation configuration is not with-in the dimensions as shown, alternative Spindles are available.
Longer Spindles can be ordered from original place of purchase. Sussex Part No. SXSPEK (12mm longer than standard)
NOTE: Seat or Breech Body extensions are NOT to be used in conjunction
with this Tapware.
Failure to adhere will void warranty.
Tapware is to be installed by a Licensed Plumber in accordance with AS/NZS
3500:2003
Recommended working water pressure 300-500 kpa. Maximum water temperature is
65 deg.c
Copyright © Sussex Taps.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>