SUSSEX RWM Circa Wall Mixer Installation Guide

SUSSEX RWM Circa Wall Mixer

Dimension

• Combined wall thickness not to exceed 30mm.
• Wall thickness greater than 30mm, contact manufacturer prior to completing rough-in.

Plumber note

• On-site testing using higher water pressures must be conducted with the Mixer in the closed position.

(STATIC TEST)

• Under no circumstances is the Mixer to be opened when exceeding the maximum stated water pressure.
• At the completion of testing, do not relieve any high water pressure by operating the Mixer.
• Exposing the internals of the Mixer Cartridge to higher than specified water pressures will void the manufacturer’s warranty.

Product code

• RWM Wall mixer
• RWM-V Wall mixer- Vertex

Rough-in plumbing

• Prior to installing, calculate the finished wall thickness to ensure the Cover Plate and Handle will fit at the final assembly.

• The Mixer Body is supplied with a plastic cover to protect Mixer Body during Plastering and Tiling.

• To aid in Plumbing, 2 Outlet Ports have been provided in the Mixer Body (Shower and Bath), but only 1 Outlet Port can be used.

• Apply thread sealant to the supplied Pressure Plug and seal either the Shower or Bath Outlet Por t not being used.

• Using the screws provided, fix the Mixer Body to a prepared

• Nogging or purpose-built frame.
  The Hot/Cold Ports are marked on the shoulder of the Mixer body to indicate the correct mounting position.

• Fix the Nogging between the Wall Studs ensuring the Mixer Body is positioned in the wall as far forward as possible.

• For best results set the Nogging so the shoulder of the Mixer body is flush with the Stud (as drawn).

• Ensure the Mixer body is aligned square after fixing the Nogging between the Studs.

• Flush all water feed lines. Allines must be free from any dirt and debris before connecting to the Mixer.

• Once all water connections are made, check the Hot/Cold water flow by operating the Mixer Cartridge.

• Leave the Mixer in the closed position and replace the protective cover, Store the remaining parts in a safe place until wall coverings have been completed and final fit-off is required (Dress finishing).

• 2.5mm Allen Key provided. (Tighten well)

Dress finishing and handle adjustment

• Apply Silicone and seal the Wall around the Mixer Body to ensure the installation is water-tight.

• Fit the Cover Plate onto the Mixer Body until it reaches the Wall covering.

• Fit the Handle Body onto the Mixer

• Car triage lever and ensure full engagement.

• Tighten the Set screw of the Handle Body using the 2.5mm Allen Key provided. (Tighten well)

• Tapware is to be installed by a Licensed Plumber in accordance with AS/NZS 3500:2003
  

• Recommended working water pressure 300-500 kph. The maximum water temperature is 65 deg.c
  

• Copyright © Sussex Taps,

• sussextaps.com.au

Documents / Resources

| SUSSEX RWM Circa Wall Mixer [pdf] Installation Guide
RWM, Circa Wall Mixer, RWM Circa Wall Mixer, Wall Mixer
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>