HEAT GLO 6KL Direct Vent Gas Fireplace Installation Guide
- June 12, 2024
- HEAT GLO
Table of Contents
6KL
Direct Vent Gas Fireplace
Specifications
Scan QR code for installation manual for final dimensions and requirements.
ACTUAL
DIMENSIONS| FRONT WIDTH| HEIGHT| DEPTH| GLASS SIZE| BTU/HOUR INPUT
---|---|---|---|---|---
41″ [1041]| 40-7/8″ [1038]| 21-7/16″ [545]| 34-1/4″ x 24-3/4″
[870 X 629]| 18,000 – 35,000 BTUs (NG)
18,000 – 34,000 BTUs (LP)
FRAMING
DIMENSIONS| FRONT WIDTH| HEIGHT| DEPTH| WEIGHT
---|---|---|---|---
42″ [1067]| 40-1/8″ [1019]| 22″ [559]| 183 LBS [83 KGS]
COMBUSTIBLE MANTEL PROJECTIONS Note: Measurement is taken from top of the
opening,NOT the top of the fireplace.
Portrait front requires taller combustible clearances or Passive Heat; see
install manual for details.
NON-COMBUSTIBLE MANTEL PROJECTIONS Note: Measurement is taken from top of
the opening,NOT the top of the fireplace.
COMBUSTIBLE MANTEL LEGS OR WALL PROJECTIONS 
NON-COMBUSTIBLE
MANTEL LEGS OR WALL PROJECTIONS
If using heat management please
refer to the fireplace installation manual for framing guidelines and reduced
mantel clearances. Additional information on venting, TV clearances, finishing
requirements, fronts, etc can be found in the installation and owner’s manual
EXTERIOR CHASE MINIMUM HEIGHT REQUIREMENTS
NOTE: If
overhang (A) is less than 2 inches, clearance from top of termination cap to
bottom of overhang (B) may be 0 inches.
A – Measured from back of vent cap to end of overhang
B – Measured from bottom of overhang to top of termination cap Vinyl Siding
Shield (TRAP-VSS) Information TRAP-VSS required if overhang (A) is greater
than 3 inches but less than 5 inches and B dimension is less than 18 inches.
TRAP-VSS recommended if either of the below is true:
– Overhang (A) is less than 5 inches (to combat water infiltration)
– A vinyl overhang is present WALL PENETRATION
DO NOT PACK VENT FRAMING HOLE WITH INSULATION OR OTHER MATERIAL. Shows
center of vent framing hole for top or rear venting. The center of the hole is
one (1) in. (25 mm) above the center of the horizontal vent pipe.
PRODUCT LISTING CODES
US| ANSI Z21.88-2019
CAN| CSA 2.33-2019
| UL307B
Product information provided is not complete and is subject to change without notice. Product installation must adhere strictly to instructions accompanying product to avoid risk of fire and potential injury.
Heat & Glo — A Brand of Hearth & Home Technologies
7571 215th Street West | Lakeville, MN 55044
877-486-9123 |
heatnglo.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>