HEAT GLO PRIMO-II-60 Series Gas Fireplace Instruction Manual
- June 12, 2024
- HEAT GLO
Table of Contents
PRIMO ll 60
Direct Vent Gas Fireplace
PRIMO-II-60 Series Gas Fireplace
Scan QR code for installation manual for final dimensions and requirements.
| FRONT WIDTH | HEIGHT | DEPTH | GLASS SIZE | BTU/HOUR INPUT |
|---|---|---|---|---|
| ACTUAL DIMENSIONS | 76-3/8″ [1940] | 40-13/16″ [1037] | 18-1/4″ [464] | 60″ x 18″ |
| [1524 X 457] | 39,500 – 57,000 BTUs (NG) |
36,500 – 50,000 BTUs (LP)
| FRONT WIDTH | HEIGHT | DEPTH | WEIGHT |
|---|---|---|---|
| FRAMING DIMENSIONS | 78-3/4″ [2000) | 45″ [1143) | 18″ (457] |
Adjust framing dimensions for interior chase sheathing (such as 1/2″ drywall)
Header depth not to exceed 5-1/2″.
If header depth is greater than 3-1/2″, header must be notched in order to
maintain clearance to pipe.
If appliance is installed off of floor, maintain required clearances to
combustibles. Construct platform in accordance to local building codes.
BASIC CORNER INSTALLATION
Reference install manual for additional venting scenarios
Specifications
COMBUSTIBLE OR NON-COMBUSTIBLE MANTELS
COMBUSTIBLE OR NON-COMBUSTIBLE MANTEL LEGS OR WALL PROJECTIONS
EXTERIOR CHASE MINIMUM HEIGHT REQUIREMENTS
WALL PENETRATION
DO NOT PACK VENT FRAMING HOLE WITH INSULATION OR OTHER MATERIAL.
- Shows center of vent framing hole for top venting. The center of the hole is one 1″ (25mm) above the center of the horizontal vent pipe.
Note: Center of the horizontal vent pipe to the vertical measuring surface of a trap cap is 5″ (127mm).
PRODUCT LISTING CODES
US| ANSI Z21.50-2019
CAN| CSA 2.22-2019
Product information provided is not complete and is subject to change without notice. Product installation must adhere strictly to instructions accompanying product to avoid risk of fire and potential injury.
Heat & Glo — A Brand of Hearth & Home Technologies
7571 215th Street West | Lakeville, MN 55044
877-486-9123 |
heatnglo.com
HNG-PRIMO-ll-60_0523