Led2 SOLO Ceiling Lamp A HF LED Instruction Manual
- June 12, 2024
- Led2
Table of Contents
Led2 SOLO Ceiling Lamp A HF LED
Product Information
The product is a Solo light fixture with various features and options for
dimming and control. It has a built-in HF sensor for motion detection and
adjustable sensitivity levels. The light level can be adjusted with different
options for color temperature. The product is IP65-rated, making it suitable
for outdoor use. It operates on 220-240V AC, 50/60Hz power supply. The
manufacturer’s website is www.led2.eu.
Product Usage Instructions
Installation
- Before installation, turn off the main power to prevent any electrical shock.
- The installation should be carried out by a technician or a qualified person.
- If the lamp has a lampshade or diffuser, handle it carefully as it is fragile.
- For fixtures with an integrated LED light source, only a technician or qualified person should perform the replacement.
HF Sensor Sensitivity
- Use the “Sensitivity” setting to adjust the sensitivity of the HF sensor.
- There are four sensitivity levels available: I (100%), II (75%), III (50%), and IV (10%).
Time Settings
- Use the “Time” setting to adjust the duration of the light after motion detection.
- There are four-time options available: 5 seconds, 90 seconds, 5 minutes, 15 minutes.
Light Level Settings
- Use the “Light level” setting to adjust the brightness of the light.
- There are four light level options available: OFF, 50 lux, 10 lux, 2 lux.
Color Temperature Switch
- Use the “Color temperature switch” to adjust the color the temperature of the light.
- The available options may vary but refer to the manual for specific instructions.
Dimming Options
- The product supports different dimming options depending on the model:
- PUSH DIM”: For use with a push dimmer.
- DALI/PUSH DIM”: For use with a DALI or push dimmer.
- DALI DIM”: For use with a DALI dimmer.
- TRIAC DIM”: For use with a phase cut (trailing edge or leading edge) dimmer.
Safety Precautions
- Always turn off the main power before installation or any maintenance work.
- The installation should only be carried out by a technician or a qualified person.
- The manufacturer is not responsible for the incorrect use or assembly of the product.
The installation may only be carried out by a technician
CONNECTION – DIMMABLE VERSION – OPTIONAL
CAUTION!
Turn off the main power before proceeding with the installation in order to
prevent possible shock. The installation may only be carried out by a
technician or a qualified person. If the lamp has a lampshade/diffuser, handle
it carefully as it is fragile. With an integrated LED light source, only a
technician or a qualified person can make the replacement. The manufacturer is
not responsible for the incorrect use and assembly of its products.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>