Maisto 81550 Mercedes G Class Radio Control Vehicles User Manual

Maisto 81550 Mercedes G Class Radio Control

Vehicles

Maisto Radio Control Vehicles

Warning! Not suitable for children under 36 months Small parts Cricking hazard. Chase Ken is es in nonmanual for future veterans. It contains important information. We reserve the right to improvertevise the product specifications without notice.

Contents

• Venice x 1
• Transmitter y 1
• Owner’s Instruction Manual x 1

Battery Requirement

• Vehicle: 2 x 1.5V *AA° LR6/R6 batteries.
• Transmitter: 2 x I.SV °AAA* LRO3/303 batterios.

Battery installation for the Transmitter

(Refer to Diagram 1)

1. Use a screwdriver to loosen the screw on the battery cover and to open the battery covet. Serenatives is not ir
2. Install 2 nom 1.5V ‘AAA” LRO3/903 batteries wih correct polarity (ale) as shown inside tha battery compartment! Install the battery cover and then tighten the screw on the battery cover,

Battery installation for the Vehicle:

(Refer to Diagrams 2 & 3)

1. Switch the power OFF.
2. Use a screwdriver to loosen the screw on the battery cover and to open the battery cover. (Screwdriver is not included)
3. Install 2 new 1.5V “AA” LR6/R6 batteries with correct polarity (+/-) as shown inside the battery compartment.
4. Install the battery cover and then tighten the screw on the battery cover.

How to play:

(Refer to Diagrams 4, 5 & 6)

1.  Set the “Power Switch” on the controller and vehicle to ON position to match the frequency.
2. If the frequency of the vehicle and controller does not match, switch off both the vehicle and controller, then tum them on again,
3. Pull the trigger in the transmitter to drive the Diagram 5 vehicle forward. Push the trigger in the transmitter to drive the vehicle backward,
4. Turn the steering knob on the transmitter to steer the vehicle to right or left.
5. If the vehicle does not run in a straight line, adjust the wheel alignment under the chassis.
6. Turn the switch of the controller and vehicle to the OFF position when not in play.

Performance Tips

1. Do not drive the vehicle on grass, sand or go through water.
2. Do not drive the vehicle in windy or rainy weather.
3. Do not drive the vehicle into any hard object.
4. Keep fingers, hair, and loose clothing away from the vehicle.
5. The operating range can be affected by a variety of factors:
   • Weak transmitter or vehicle batteries.
   • Interference from other items that emit radio frequency signals such as another R/C item on the same frequency, CB radios, cordless phones, high voltage transformers, etc.
6. Outdoor usage is recommended in order to get optimal control range.

Battery use

1. Alkaline batteries are recommended.
2. Only batteries of the same or equivalent type as recommended are to be used.
3. Do not mix alkaline, standard or rechargeable batteries.
4. Do not mix old and new batteries or different type of batteries.
5. Non-rechargeable batteries are not to be charged,
6. Rechargeable batteries are only to be charged under adult supervision.
7. Rechargeable batteries are to be removed from the product before they are charged.
8. Be sure to insert batteries with correct polarities and always follow the battery manufacturer’s instructions.
9. Remove all batteries from the product when not in use for long periods of time.
10. Exhausted batteries are to be removed from the product.
11. he supply terminals are not to be short-circuited,
12. Dispose of batteries properly. Do not dispose of batteries in fire -it may cause them to explode or leak causing injury or damage.
13. Battery change must only be made by adult.

Cautions

1. Do not attempt to disassemble the products.
2. Do not operate the vehicle with same frequency with other players in same location. This will interfere and cause the vehide to lose control.
3. Make sure the batteries are installed with correct polarity (+/-) as shown inside the battery compartment.
4. Remove the package, take out all accessories and assemble the product before giving it to children to play.

FCC Label Compliance Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions :

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Warning : Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

RSS-210 Compliance Statement

This device contains license-exempt transmitters)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference;
2. This device must accept any interference, including interference that may cause undesired operation of the device.

Troubleshooting

Environmental notes

The whole product also does not belong to household waste at the end of the product life. You can return it at collection points for the recycling of electronic and electronical instruments. The symbol on the item, instruction manual, hanglag or packing is showing this clearly.

Materials should be recycled according to their respective markings. Recycling of old devices or other re-use of materials contained therein represents an important contribution to environmental protection

Please ask all your local community for the correct collection point.

Please retain this sheet and address for future use, as they contain important information.

Disposal of batteries
Batteries should not be disposed of in the household waste. As the consumer you are legally obliged to return batteries containing harmful substances and all other used batteries. You can hand in your old batteries at public collection points in your area or wherever batteries are sold. You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing harmful substances:

• Pb = Battery contains lead
• Cd = Battery contains cadmium
• Hg = Battery contains mercury

CE Declaration

Hereby, MAY CHEONG GROUP FRANCE S.A.S., declares that this equipment is in compliance with the essential requirements and other relevant provisions of directive 2014/53/EU.

• Frequency: 2.4GHz
• Transmitting frequency band: 2.4-2.4835GHz
• Max allowed transmitting power: <10mW

The declaration of conformity may be consulted at MAY CHEONG GROUP FRANCE S.A.S.; Parc Ariane • Le Vénus, 2 rue Hélène Boucher, 78280 Guyancourt, France.

The full text of the EU Declaration of conformity is available at the following internet address: www.maycheonggroup.com.hk/declaration-of- conformity

MADE IN CHINA

www.maisto.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>