TRAVIS INDUSTRIES 96100392 Large Flush Wood Insert Rectangular 1 Piece Surround Panel Installation Guide
- June 12, 2024
- TRAVIS INDUSTRIES
Table of Contents
TRAVIS INDUSTRIES 96100392 Large Flush Wood Insert Rectangular 1 Piece
Surround Panel
Product Information
This product is the Large Flush Wood Insert Rectangular with a 1 Piece Surround Panel Installation. It is available in two different SKUs: 96100392 and 96100393.
The surround panel sizing for each SKU is as follows:
- SKU 96100392: Height – 32-1/2, Width – 42
- SKU 96100393: Height – 35, Width – 47
The product comes with a packing list that includes all the necessary hardware for installation.
Product Usage Instructions
- Before starting the installation, ensure that the insert is in place and the flue is attached.
- Attach the brackets to the insert using the screws provided in the hardware pack. Make sure the brackets are flush with the front of the convection chamber.
- Next, attach the surround panel to the brackets.
WARNING: It is important to ensure that all wiring is inserted into the
cavity between the insert and the fireplace. Failure to do so may result in
damage to the wiring.
HINT: When installing the panel, route the wires through the notch on the
bottom of the panel on either side.
Compatibility
- Large Flush Wood Hybrid-Fyre Insert
Surround Panel Sizing
Height | Width | |
---|---|---|
96100392 | 32-1/2” | 42” |
96100393 | 35” | 47” |
Packing List
- Surround Panel
- (2) Panel Mounting Brackets
- (6) #10 screws (included with insert hardware pack)
Installation
- Before installing, the insert should be in place with the flue attached. Attach the brackets as shown below, using the screws included in the hardware pack with the insert. Make sure the brackets are flush with the front of the convection chamber
- Attach the surround panel as shown below.
WARNING : Make sure all wiring is inserted into the cavity between the
insert and the fireplace. Failure to do this may cause the wiring to become
damaged
HINT : When installing the panel, route the wires through the notch on
the bottom of the panel (either side).
© Travis Industries, Inc.