dewenwils HIDT01A Indoor Outdoor Timer Instruction Manual
- June 12, 2024
- dewenwils
Table of Contents
Indoor Countdown Timer
SKU: HIDT01A
[Instruction Manual] 
V20718
Please pay attention to the warning signs
Read the instructions with caution before operating and keep it properly
WARNING
To reduce the risk of fire, electric shock or personal injury, please strictly
follow the instructions.
- Do not connect any devices which exceed the maximum ratings of the timer.
- Do not immerse in water.
- Children are not allowed to use the timer without supervision.
- Do not disassemble or repair the product, but only by authorized service personnel.
- Always unplug and store indoors when not in use.
Product Layout
- “15 Min” : On for 15 minutes then Off.
- “30 Min” : On for 30 minutes then Off.
- “1H” : On for 1 hour then Off.
- “2H” : On for 2 hours then Off.
- “4H” : On for 4 hours then Off.
- “ON/OFF” : Indicates the power output, on or off. Press it to override the current output on or off.
- “+” : Adding extra time from current settings, press “+” button to extend the countdown time range.
- “Repeat” : Repeats the current setting after 24 hours.
Operating Instructions
Countdown timer
There are six countdown timers, press the time button to start your countdown
timer. The backlit of time button you press will be lighted,and the ON/OFF
button will be lighted simultaneously. The backlit of buttons will be off
while the countdown time ends.
“15 Min” – Start a 15 minutes countdown timer;
“30 Min” – Start a 30 minutes countdown timer;
“1H” – Start an one hour countdown timer;
“2H” – Start a two hours countdown timer;
“4H” – Start a four hours countdown timer;
“+” – When one of the above time buttons is pressed, then press “+”and another
time button to increase your countdown time range.The time buttons can only be
pressed once.
Maximum time using “+” button is 7 hours and 45 minutes.(15min+30min+
1H+2H+4H)
Manual on/off
Press “ON/OFF” to turn the power on or off, or to override any current
settings.
Repeat feature
When the countdown timer is set to desired time (15min, 30min, 1H, 2H or 4H),
press Repeat button to repeat the current countdown timer after 24 hours.
Repeat feature will continue every 24 hours until “Repeat”button is pressed
and no longer lit.
Remark
- All buttons are backlit for easy reading. Press button again to turn off the backlit and inactivate the countdown timer or the button function.
- If timer is unplugged, all settings must be reset.
- Repeat button must be pressed after desired time button is set in order for it to work.
Specifications
Input Voltage ：
– 125V, 60Hz.
Max Power Rating ：
– 125V, 60Hz, 1875W,
– 15A Resistance,
– 15A General Use,
– 1000W Tungsten,
– 500VA Electronic Ballast,
– 120Vac, 60Hz, 8.3A Ballast,
– 1/2HP.
Safety Information
Federal Communications Commission Interference Statement This equipment has
been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause interference, and(2) this device must accept any
interference, including interference that may cause undesired operation of the
device.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
One Year Limited Warranty
Supported by our professional R&D team and QC team, we provide One Year
Warranty for materials and workmanship from the purchase date. Please note
that the warranty does not cover damage caused by personal misuse or improper
installation.
Please attatch your Order ID and Name so that our dedicated customer service
team can help you better.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>