Ikonart Stencil Kit 2.0 LED Exposure Unit for Stencil Film User Guide
- June 5, 2024
- IKONART
Table of Contents
Ikonart Stencil Kit 2.0 LED Exposure Unit for Stencil Film
EXPOSURE UNIT PARTS
ATTACH STAND ARM TO STAND BASE
Place the stand base on the table with the countersunk side of the hole on
the bottom. Insert the shorter screw through the hole from the bottom. Attach
the stand arm and tighten with the Allen wrench.
ATTACH LIGHT ARM TO STAND ARM
Place the light arm on top of the stand arm with the countersunk side of
the holes facing up. Align the light arm over the center of the stand base.
Insert one long screw through the light armhole and into the stand armhole.
Tighten with the Allen wrench.
ATTACH LIGHT TO LIGHT ARM
Insert one long screw through the remaining hold on the top of the light
arm. Attach the LED Light through the middle hole of the light (the glass of
the light should be parallel to the base; the light cord should be parallel
with the light arm). Use the wing nut to secure the light to the light arm.
ADDITIONAL INFORMATION
- BLACK CARDBOARD: The matte black cardboard that was needed for our original acrylic Ikonart Exposure Stand is no longer needed on this matte black metal stand.
- CAUTION: When working with ultraviolet light, it is important to take the necessary precautions to avoid injury. Avoid looking directly at the light.
- WARNING: Electrical product. As with all electrical products, precautions should be observed during handling and use to reduce the risk of electrical shock. If the cord is damaged, it must be replaced by a qualified technician to avoid a hazard.
- WARNING: This product is not a toy. Choking hazard — contains small parts. Not for children under 12 years.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>