dewenwils HODT21A Outdoor Light Sensor Timer Instruction Manual
- June 13, 2024
- dewenwils
Table of Contents
Outdoor Light Sensor Timer
SKU: HODT21A
[Instruction Manual]
HODT21A Outdoor Light Sensor Timer
Please pay attention to the warning signs Read the instructions with caution
before operating and keep it properly
To reduce the risk of fire, electric shock or personal injury, please strictly
follow the instructions.
- Do not connect any devices which exceed the maximum ratings of the timer.
- Do not immerse in water.
- Children are not allowed to use the timer without supervision.
- Do not disassemble or repair the product, but only by authorized service personnel.
- Always unplug and store indoors when not in use.
- INSTALL THE CORD AND UNIT ABOVE GROUND LEVEL AT LEAST 1.4 M WITH THE RECEPTACLE FACING DOWNWARD.
- SUITABLE FOR USE WITH OUTDOOR APPLIANCES – RAINTIGHT WHEN MOUNTED VERTICALLY WITH THE RECE PTACLE FACING DOWNWARD.
NOT FOR WATER IMMERSION.STORE INDOOR WHEN NOT IN USE.
Product Layout
- Timer dial: 2 to 8 hours or dusk to dawn and daily repeat function.
- Power: Power indicator light indicates if the timer is turned on or off.
- Sensor: Sensor will turn timer on at dusk and off at dawn.
- 1 Outlet: Plug the lights or device to be controlled by the timer into outlet.
Operating Instructions
OFF: Power is OFF to attached devices
ON: Power is ON to attached devices
Dusk – Dawn: Power will turn on at dusk and remain on until dawn
2 Hrs: Power will turn on at dusk and remain on for 2 hours
4 Hrs: Power will turn on at dusk and remain on for 4 hours
6 Hrs: Power will turn on at dusk and remain on for 6 hours
8 Hrs: Power will turn on at dusk and remain on for 8 hours
Cycle repeats every 24 hours
Notes
- The timer is daily repeat after setting, in case of power failure, it will stop operating. Once power is restored, reset the desired operating mode as the operating instructions.
- Once programming activates at dusk in the 2H, 4H, 6H, or 8H Mode, the program cycle will repeat until the timer is reset. Headlights, porch lights, street lamps and other external lighting sources will not interfere with the active timer program.
- in the Dusk- Dawn Mode, temporary light sources like headlights, porch lights and other external light sources will not interfere with the photocell function unless the external light source is on for more than 15 minutes. In that case, the timer will shut off until darkness is restored.
- When set to “ON, the timer will provide continual power to attached devices until the timer is switched to “OFF”, o to any of other operating modes.
Specifications
Input Voltage:
- 125V, 60Hz
Max Power Rating:
- 125V, 60Hz, 1250W,
- 10A Resistance,
- 10A General Use,
- 1000W Tungsten,
- 500VA Electronic Ballast,
- 120Vac, 60Hz, 8.3A Ballast,
- 112HP.
Cord:
- SJTW 18/3 AWG
Safety Information
Federal Communications Commission Interference Statement This equipment has
been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment
One Year Limited Warranty
Supported by our professional R&D team and QC team, we provide One Year
Warranty for materials and workmanship from the purchase date Please note that
the warranty does not cover damage caused by personal misuse o improper
installation
Please attach your Order ID and Name so that our dedicated customer service
team can help you better.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>