dewenwils HODT11C Outdoor Digital Timer Instruction Manual

dewenwils HODT11C Outdoor Digital Timer

Product Information

• Product Name: Outdoor Digital Timer
• SKU: HODT11C
• Electrical Ratings:
  • Input Voltage: 125V, 60Hz
  • Max Power Rating: 125V, 60Hz, 1625W, 13A Resistance, 13A General Use, 1000W Tungsten, 500VA Electronic Ballast, 120Vac, 60Hz, 8.3A Ballast, 1/2HP
  • Cord: SJTW 16/3 AWG

Please pay attention to the warning signs Read the instructions with caution before operating and keep it properly.

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK OR PERSONAL INJURY, PLEASE STRICTLY FOLLOW THE IN-STRUCTIONS.

1. SUITABLE FOR USE WITH OUTDOOR APPLIANCESRAINTIGHT WHEN MOUNTED VERTICALLY WITH THE RECEPTACLE FACING DOWNWARD. NOT FOR WATER IMMERSION.STORE INDOOR WHEN NOT IN USE.
2. INSTALL THE CORD AND UNIT ABOVE GROUND LEVEL AT LEAST 1.4 M WITH THE RECEPTACLE FACING DOWNWARD.
3. DO NOT CONNECT ANY DEVICES WHICH EXCEED THE MAXIMUM RATINGS OF THE TIMER.
4. DO NOT IMMERSE IN WATER.
5. CHILDREN ARE NOT ALLOWED TO USE THE TIMER WITHOUT SUPERVISION.
6. DO NOT DISASSEMBLE OR REPAIR THE PRODUCT, BUT ONLY BY AUTHORIZED SERVICE PERSONNEL.
7. ALWAYS UNPLUG AND STORE INDOORS WHEN NOT IN USE.

Product Layout

1. Light Sensor
   Sensor will turn timer on at dusk and off at dawn.

2. Display
   Indicates current operating mode.

3. Select Button
   To select and switch the operating mode.

Operation Instructions

Plug the timer into a standard outlet, and then press the button on the timer to select one of the following settings:

• Cycle repeat every 24 hours
• Once activates at dusk in the specific mode, the program cycle will be completed. Any light sources won’t interfere with the program cycle.

HELPFUL TIPS

• When set to”ON”, the timer will provide continual power to attached devices until the timer is switched to “OFF”, or to any of the other operating modes.
• In the sensor mode, temporary light sources like headlights, porch lights and other external light sources will not interfere with the photocell function unless the external light source is on for more than 15 minutes. In that case, the timer will shut off until darkness is restored. The improvement avoids the flickering.
• Once programming activates at dusk in the 1-9 hr mode, the program cycle will complete before the timer resets. Headlights, porch lights, street lamps and other external lighting sources will not interfere with the active timer program.

Electrical Ratings

• Input Voltage:
  • 125V, 60Hz.
• Max Power Rating:
  • 125V, 60Hz, 1625W,
  • 13A Resistance,
  • 13A General Use,
  • 1000W Tungsten,
  • 500VA Electronic Ballast,
  • 120Vac, 60Hz, 8.3A Ballast,
  • 1/2HP.
• Cord:
  • SJTW 16/3 AWG.

Safety Information

Federal Communications Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause interference, and(2) this device must accept any interference, including interference that may cause undesired operation of the device.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

One Year Limited Warranty

Supported by our professional R&D team and QC team, we provide One Year Warranty for materials and workmanship from the purchase date. Please note that the warranty does not cover damage caused by personal misuse or improper installation. Please attatch your Order ID and Name so that our dedicated customer service team can help you better.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>