RUIZHI RZ066 433M Wireless Remote Control User Manual
- June 13, 2024
- RUIZHI
Table of Contents
RZ066 433M Wireless Remote Control
User Manual
Functional characteristics
RZ 066 is a 433M wireless remote control, powered through two 7 batteries, with the advantages of strong transmission power, long remote control distance, low power consumption! There are 4 buttons, which with the 433M receiving module!
Remote control key correspondence
Basic functional operation
3.1 When the treadmill is powered on, short press the start key on the remote
control, and the treadmill reverses and starts running
3.2 When the treadmill is running, short press the stop key on the remote
control to make the treadmill slow down until the running belt completely
stops
3.3 When the treadmill is running, press the speed button on the remote
control to accelerate slowly, and press this button to accelerate quickly.
3.4 When the treadmill is running, press the speed reduction key to slow down
slowly, and press this key to slow down quickly.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>