BEGA 33 632 Ceiling and Wall Luminaire Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
BEGA 33 632 Ceiling and Wall Luminaire Instruction Manual
Instructions for use
Application
Ceiling and wall luminaire made of aluminium and hand-blown satin matt three-
ply opal glass. For a variety of interior and exterior lighting applications.
Ideal for places where a soft and uniform lighting distribution is required.
Product description
- Luminaire made of aluminium and stainless steel
- BEGA Unidure® coating technology
- Opal glass, satin matt, with screw neck
- Silicone gasket
- Reflector made of pure anodised aluminium 2 mounting holes ø 6mm
- Distance apart 240mm 2 cable entries for through-wiring of mains
- supply cable ø 7-10.5mm
- Connection terminal 2.5@
- Earth conductor connection
- Lampholder E 27
- Safety class I
- Protection class IP 64
- Dust-tight and protection against splash water
- Impact strength IK03
- Protection against mechanical impacts < 0.35 joule
- Safety mark
- Conformity mark
- Weight: 2.5 kg
Safety
The installation and operation of this luminary are subject to national safety
regulations. Installation and commissioning may only be carried out by a
qualified electrician.The manufacturer accepts no liability for damage caused
by improper use or installation. If subsequent modifications are made to the
luminary, the person responsible for these modifications shall be considered
the manufacturer.
Lamps
Luminary with screw base E 27
Lamp output max. 2 × 60 W
This product contains light sources of energy efficiency classes E, F
Supplied lamp
2 × BEGA LED lamp 13584
LED Retrofit 7 W · 1610 lm · 3000 K
Luminary efficiency: 37%
Additional BEGA LED lamps are available for this luminaire:
13 586 LED 7 W · 805 lm · 3000 Kdimmable
13 588 LED 8 W · 1055 lm · 3000 K
13 590 LED 12 W · 1400 lm · 3000 K
13 592 LED 12 W · 1400 lm · 3000 K dimmable
Detailed technical and lighting data for the lamps can be found in the data sheets on our website.
Installation
Lead the mains supply cable through the cable entry into the luminary housing.
For wall installation note the position of application “arrow down”.
Fix luminary base with enclosed or any other suitable fixing material onto the
mounting surface.
Be sure to use the gasket rings supplied.
Make earth conductor connection.
Push silicone sleeves over the lines and make electrical connection.
Insert lamp.
Screw glass clockwise into the luminary baseagainst the gasket .
Make sure that gasket is positioned correctly
Relamping · Maintenance
Disconnect the electrical installation.
Open the luminaire and clean.
Use only solvent-free cleaning agents. Change the lamp.
Check the gasket and replace, if necessary.
Close the luminary.
For cleaning, do not use high pressure cleaners.
Spares
Spare glass with gasket 11 002 778 40
LED lamp 3000K 13 584
Lampholder 63 000 355
Reflector 76 000 678
Gasket glass 83 000 372
2/2 BEGA Gantenbrink-Leuchten KG · Postfach 3160 · 58689 Menden
info@bega.com
www.bega.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>