CyberPower GS60304 6-Outlet Power Strip User Manual

: June 12, 2024
: CyberPower

Table of Contents

FEATURES
SPECIFICATIONS
TROUBLESHOOTING
Documents / Resources

YOUR ULTIMATE ALLY IN POWER
6-OUTLET POWER STRIP
GS60304
USER MANUAL

CyberPower GS60304 6 Outlet Power Strip

FEATURES

ON/OFF Reset Switch Breaker
Control power to all outlets. The switch is also a 15A breaker. When an overload occurs, it will automatically switch of. To resume operation, ensure the overload condition is corrected and reset the surge protector by switching the unit ON.
Six Standard Outlets
3-ft. Power Cord
Keyhole Mounting Slots (on back)

SPECIFICATIONS

Model Number:	GS60304
Outlets:	6 Standard Outlets
Electrical Rating:	125V / 15A / 1875W
Response Time:	Less than 1 nanosecond
Circuit Breaker:	15 Amp

WARNING: This product can expose you to chemicals including bisphenol A (BPA) and styrene (ABS), which is known to the State of California to cause reproductive harm and cancer. For more information, go to www.P65Warnings.ca.gov ..

CAUTION
TO REDUCE THE RISK OF ELECTRIC SHOCK:
Use only in dry locations and only indoors.
DO NOT plug into another relocatable power tap.
DO NOT “daisy chain” surge protectors.
DO NOT use with any aquarium equipment.
DO NOT use if properly grounded outlets are not available.
DO NOT install this device if there is less than 10 meters (30 feet) of wire between the electrical outlet and electrical service panel.
DO NOT use for medical or life support equipment. This device features an internal protection that will disconnect the surge protective component at the end of its useful life, but it will maintain unprotected power to the load.

TROUBLESHOOTING

If the ON/OFF is switched of, the 15 AMP circuit breaker may have tripped.
Examine your connected equipment and remove the device that is overloading the circuit. Then, turn the ON/OFF switch back to RESET.

FOR MORE INFORMATION
Visit CyberPowerSystems.com for more information regarding:

Product information and certifications
Product warranty
Connected equipment guarantee

TECHNICAL SUPPORT
Visit:CyberPowerSystems.com/support
Toll-Free : 1-877-297-6937
Hours of Operation : Monday – Friday: 7:00am – 6:00pm CST
© 2023 Cyber Power Systems (USA), Inc. All rights reserved.
All other trademarks are the property of their respective owners.

CONFORMANCE APPROVALS
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment of and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
Consult the dealer or an experienced radio/TV technician for help. that to which the receiver is connected.

WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Cyber Power Systems (USA), Inc.
4241 12th Avenue East, Suite 400 | Shakopee, MN 55379
CyberPowerSystems.com