teesa TSA8073 Automatic Soap Dispenser Owner’s Manual

teesa TSA8073 Automatic Soap Dispenser

SAFETY INSTRUCTIONS

1. Read this instruction manual carefully, even if you are familiar with the appliance. Keep the manual for future reference.
2. Avoid using/storing the product it in extreme temperatures. Do not expose it to direct sunlight and sources of heat.
3. Product intended for household use only.
4. Do not use the product for purposes different from displayed in this operating manual.
5. Keep the appliance out of the reach of children.
6. Place the appliance on a dry, flat and stable surface.
7. Do not drop the device or subject it to strong impacts.
8. Do not place the appliance in water or any liquid; nor handle/use it with wet or moist hands.
9. Do not attempt to repair this appliance yourself. Never disassemble this appliance.
10. In case of damage, contact with an authorized service point for a check-up/repair

PRODUCT DESCRIPTION

1. Container lid
2. Soap inlet
3. On/off switch
4. Spout
5. Motion sensor
6. LED diode
7. Battery compartment

BATTERY INSTALLATION

1. Turn over the soap dispenser to access battery compartment.
2. Rotate the cover counterclockwise and remove it.
3. Insert 4x AAA battery with correct polarization.
4. Replace the cover and rotate it clockwise to lock it in place.

Notes:

• Use only specified batteries.
• Do not mix different types of batteries.
• Replace all batteries at the same time.

FILLING THE CONTAINER
The soap dispenser is compatible with liquid soap. When using thicker liquids such as dish soap, it is required to mix it with water. Otherwise, the dispenser may not be able to draw out the product. The ratio of water to soap is recommended to be 3~8:1 (depending on used liquid). Avoid using liquids that are too thick. Do not use with granular or pearlescent soaps.

1. Rotate the container lid counterclockwise to unlock it then remove it.
2. Pour soap inside the container. Do not overfill as this may cause dripping.
3. Replace the plug and rotate it clockwise to lock it back in place.

USE

1. Press the on/off switch to turn on the device. Red LED flashes twice.
2. Place your hands under the spout to activate the motion sensor. For first time use, it may be necessary to repeat this process several times until the soap begins to dispense. The device will automatically dispense soap (red LED is on during dispensing). When the device is on, it will dispense foam soap every time it senses motion under the spout within the required distance. Red LED flashes once every 10 seconds when the device is on.
3. There are 3 dispensing volume settings available. With each press, dispensing volume increases (red LED flashes 2 times, 3 times and 4 times to indicate chosen setting).
4. Wash your hands.
5. Press and hold the on/off switch to turn off the device. The red LED is on when the button is being pressed then goes off.

CLEANING AND STORAGE

• Prior to cleaning, make sure the device is switched off.
• Gently wipe the housing of the dispenser with a soft, slightly damp cloth. Wipe the motion sensor with a soft, dry cloth.
• Batteries should be removed from the device if it is not going to be used for a long period of time.

Correct Disposal of This Product (Waste Electrical & Electronic Equipment)
It is forbidden to place equipment waste marked with the symbol of a crossed- out trash bin together with other waste. This equipment is subject to collection and recycling. The harmful substances it contains can cause environmental pollution and pose a threat to human health.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>