VISUAL COMFORT TOB 4355 Ace Flush Mount Instruction Manual
- June 12, 2024
- VISUAL COMFORT
Table of Contents
ASSEMBLY INSTRUCTIONS
Ace 7″ Flush Mount
Item # TOB 4355
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect item and contents
carefully. If any damage or defect is found, do not install. Retain all
packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Phillips Screwdriver Slotted Screwdriver Drill
Pencil Hammer
1. Carefully remove all parts from the box. Place on a clean, soft surface.
2. Remove fixture body (D) from mounting plate (A) by unscrewing.
3. Remove mounting plate (A) from light source (J) by removing
threaded caps (E).
4. Using mounting plate (A) as a guide, line up with the junction box and
mark anchor positions.
5. Using a drill bit slightly smaller than the anchor, drill holes in the
marked positions. Install anchors (L) into the holes using hammer.
6. Install mounting plate (A) to the junction box and secure with
mounting screws (B) , then secure wood screws (K) to anchors (L).
7. Remove quick connector (I) from light source.
8. Wrap quick connector ground wire (bare copper) around the green grounding
screw (see diagram 1). Tighten. Continue quick connector ground wire and
connect to supply ground wire (usually green or bare copper) using wire nut
(C).
NOTE: It is imperative that the fixture is grounded.
9. Connect quick connector neutral wire (white) to the supply neutral wire
(usually white) using wire nut (C).
10. Connect quick connector hot wire (black) to the supply hot wire (usually
black) using wire nut (C).
CAUTION: Do not reverse the hot and neutral connections.
11. Make sure all wire connections are tight, then carefully tuck into the
junction box.
12. Connect quick connectors ( I & H) together (see diagram 2), then
install light source (J) to threaded nipple (G) and secure with
threaded caps (E).
13. Loosen thumbscrews (M) from shade bracket, then install glass shade
(F) to fixture body (D) and secure with thumbscrews (M).
NOTE: Do not over-tighten otherwise shade could become damaged.
14. Align studs (N) on mounting plate (A) with slots on fixture body
(D) , then turn clockwise until locked in place. See diagram 3.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do Not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>