TECNO BF6 Smartphone User Manual
- June 12, 2024
- TECNO
Table of Contents
TECNO BF6 Smartphone
Product Information
- Front camera
- Volume + key
- Volume – key
- Power key & side fingerprint sensor
Product Usage Instructions
SIM/SD card installation
- Power off your mobile device.
- Refer to the provided picture for SIM/SD card installation.
Charging the phone
You can charge your device using a charger or by connecting it to the computer
using a USB cable (comes with the phone).
- Ensure the correct orientation of the plug when connecting the charger.
- Use only TECNO charger and cables. The use of other chargers or cables may damage the device and invalidate your phone warranty.
FCC Caution – Labelling Requirements
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including
interference that may cause undesired operation.
Information to the user: Any changes or modifications not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Specific Absorption Rate (SAR) information: This mobile phone meets the
government’s requirements for SAR.
Explosion diagram specification
1| F L ( C T P + L C M )| 2| U PPER ___ HOU S
I N G
---|---|---|---
3| FRONT_CAM_RUBBER| 4| _FRONTCAM
5| BACK_CAM_CON_FOAM| 6| BACK_CAM_1
7| BACK_CAM_2| 8| MAIN_PCB
9| RECEIVER| 10| FRONT_CAM_CON_FOAM
11| LOWER_A_HOUSING| 12| BATTERY_HOUSING
13| BACK_CAM_LENS_1| 14| BACK_CAM_LENS_2
15| DECO_LENS| 16| KATUO
17| LOWER_B_HOUSING| 18| LCD_50BTB_RUBBER
19| FINGERPINT_MODULE| 20| RF_CABLE
21| EARPHONE_RUBBER| 22| LCD_30BTB_RUBBER
23| SUB_PCB| 24| USB_RUBBER
25| MOTOR| 26| SIDEKEY_FPC
27| BATTER| 28| SPEAKEY
29| SPK_FPC| |
Know your phone
- Front camera
- Volume + key
- Volume – key
- Power key & side fingerprint sensor
SIM/SD card installation
- Power off mobile.
- Refer to the following picture for SIM / SD card installation.
Charging the phone
You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone).
- Please remind the front and back of the plug.
- Use only TECNO charger and cables. Other chargers or cables may damage the device. This will invalidate your phone warranty.
FCC Caution
Labelling requirements.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Information to user.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Information to the user.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This mobile phone meets the government’s requirements for exposure to radio
waves. The guidelines are based on standards that were developed by
independent scientific organizations through periodic and thorough evaluation
of scientific studies. The standards include a substantial safety margin
designed to assure the safety of all persons regardless of age or health.
FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is
1.6W/kg averaged over one gram of tissue. Device types: BF6 (FCC ID: 2ADYY-
BF6) has also been tested against this SAR limit. The highest SAR value
reported under this standard during product certification for use at the ear
is 1.17 W/kg and when properly worn on the body is 0.58 W/kg.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 1.0 cm must be
maintained between the user’s body and the handset, including the antenna.
Third-party belt-clips, holsters, and similar accessories used by this device
should not contain any metallic components. Body-worn accessories that do not
meet these requirements may not comply with RF exposure requirements and
should be avoided. Use only the supplied or an approved antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>